This article is devoted to the investigation of the characteristics of a low-emission gas turbine combustion chamber, which can be used in Floating Production, Storage and Offloading (FPSO) vessels and operates on a mixture of natural gas and hydrogen. A new approach is proposed for modelling the processes of burning out a mixture of natural gas with hydrogen under preliminary mixing conditions in gaseous fuel with an oxidizer in the channels of radial-axial swirlers of flame tubes. The proposed kinetic hydrocarbon combustion scheme is used in three-dimensional calculations for a cannular combustion chamber of a 25 MW gas turbine engine for two combustion models: the Finite-Rate/Eddy-Dissipation and the Eddy Dissipation Concept. It was found that, for the investigated combustion chamber, the range of stable operations, without the formation of a flashback zone in the channels of radial-axial swirlers, is determined by the hydrogen content in the mixture, which is less than 25-30% (by volume). For the operating modes of the chamber without the formation of a flashback zone inside the swirler channels, the emissions of nitrogen oxide NO and carbon monoxide CO do not exceed the values corresponding to modern environmental requirements for emissions of toxic components by gas turbine engines.
16 September 2015 in IEEE Transactions on Plasma Science
This paper presents the results of theoretical and experimental investigations of a developed synthesis gas afterburner based on an injector type plasma-assisted combustion system. The basic overall dimensions of the afterburner with the injecting device are determined. The design concept can provide higher performance, wider turndown ratios, more efficient synthesis gas combustion, and satisfaction of major ecological requirements.
20 September 2016 in IEEE Transactions on Plasma Science
This paper shows the results of studying the influence of a plasma-chemical stabilizer on the pulse parameters of a gas turbine low emissive combustor. It is found out that the increase of the processes stability in low emissive gas turbine combustors with preliminary formation of air-fuel mixture may be reached due to plasma-chemical influence of the plasma-assisted systems based on low-current discharges on the processes of mixture formation and chemical kinetics.
12 December 2007 in IEEE Transactions on Plasma Science
The major advantages of plasma treatment systems are cost effectiveness and technical efficiency. A new efficient electrodeless 1-MW hybrid plasma torch for waste disposal and coal gasification is proposed. This product merges several solutions such as the known inductive-type plasma torch, innovative reverse-vortex (RV) reactor and the recently developed nonequilibrium plasma pilot and plasma chemical reactor. With the use of the computational-fluid-dynamics-computational method, preliminary 3-D calculations of heat exchange in a 1-MW plasma generator operating with direct vortex and RV have been conducted at the air flow rate of 100 g/s. For the investigated mode and designed parameters, reduction of the total wall heat transfer for the reverse scheme is about 65 kW, which corresponds to an increase of the plasma generator efficiency by approximately 6.5%. This new hybrid plasma torch operates as a multimode, high power plasma system with a wide range of plasma feedstock gases and turn down ratio, and offers convenient and simultaneous feeding of several additional reagents into the discharge zone.
13 October 2011 in IEEE Transactions on Plasma Science
Theoretical and experimental investigations of the working processes in a gas turbine low-emission combustor, in which the principle of lean burning of a partially premixed mixture is realized, have been conducted. The selected concept of a gas turbine combustor can provide higher performance and lower emission of nitrogen oxides and demonstrate satisfactory major gravimetric and volumetric parameters. The obtained results and recommendations can be used for the gas turbine combustor operation mode modeling, geometry optimization, prospective propulsion, and power generation unit design and engineering.
23 August 2010 in IEEE Transactions on Plasma Science
Theoretical and experimental investigations of the working processes in a plasma-assisted combustion and reformation system have been conducted. The selected concept can provide higher performance, wider turndown ratios, more efficient propellant utilization, demonstration of potential fuel flexibility, and satisfaction of major gravimetric and volumetric density requirements. Obtained results and recommendations can be used for hybrid-type plasma-assisted system operation modes, including modeling, geometry optimization, prospective propulsion, and power-generation unit designs and engineering.