When a flat plate impacts water at small deadrise angles, the air cushion underneath plate bottom is asymmetrical about plate center and produces great asymmetrical impact pressure. In such an occasion, the motion response of plate should be very complicated and is highly coupled with air cushioning effect, particularly, the pitching motion which will alter the transient deadrise angle. However, the existing studies only considered the vertical translational motion, both the horizontal translational motion and pitching motion are restricted. In this paper, the complete motion behavior of plate induced by air cushioning effect during the water impact at small deadrise angles is numerically studied. In the regime of impact velocity and deadrise angle, four typical plate motion patterns have been discovered based on the variation characteristics of pitch angle: pitching-down, fluctuating-pitching-down, pitching-up-down, and pitching-up. To elucidate the underlying mechanism, the water impact process of plate at small deadrise angles is investigated, which contains four distinct stages: keel compression, edge compression, fluid expansion, and reloading. The pitching motion patterns are mainly determined by the keel compression and edge compression stages. In the keel compression stage, the air underneath plate keel is compressed and produces a pitching-down moment; in the following edge compression stage, the air underneath plate edge is heavily compressed and produces a strong pitching-up moment. Further, the influence of impact velocity and deadrise angle on the pitching motion has been investigated.
1 January 2015 in Theoretical and Applied Mechanics Letters
Aerodynamic performance of the high-altitude propeller, especially the counter rotation effects, is experimentally studied. Influences of different configurations on a stratospheric airship, included 2-blade counter-rotating propeller (CRP), dual 2-blade single rotation propellers (SRPs) and 4-blade SRP, are also indicated. This research indicates that the effect of counter rotation can greatly improve the efficiency. It shows that the CRP configuration results in a higher efficiency than the dual 2-blade SRPs configuration or 4-blade SRP configuration under the same advance ratio, and the CRP configuration also gains the highest efficiency whether under the situation of providing the same trust or absorbing the same power. It concludes that, for a stratospheric airship, the CRP configuration is better than the multiple SRPs configuration or a multi-blade SRP one
The flow control effect of the trailing-edge Gurney flap (TG) on the dynamic lift characteristics for a 50°-swept delta wing during large-amplitude pitching oscillations at various reduced frequencies (k = 0.072, 0.144, 0.287, and 0.575) was investigated via force, particle image velocity, and dye visualization measurements in a water channel facility. Numerical simulations were carried out to further understand the flow control mechanism of the TG in low and high reduced frequency cases (k = 0.072 and 0.575). It was found that as the reduced frequency increases, the lift increments brought by the TG are magnified and abated during the upstroke and downstroke processes, respectively. The breakdown of the leading-edge vortex (LEV) on the upper surface of the wing is promoted by the TG during the early stage of the pitching cycle. The lift enhancement being benefited by the TG is mainly contributed by the recovery of lower surface pressure along the trailing edge due to the blockage effect of TG, which also stimulates the spanwise flow and strengthens the LEV upon the upper surface. The significant lift increment contribution of the upper surface during the upstroke process can be maintained to higher angle of attack as the reduced frequency increases.