This paper discusses the results of simulations relating to the performances of turbo codes, low density parity check (LDPC) codes, and polar codes over an additive white Gaussian noise (AWGN) channel in the presence of inter symbol interference, denoting the disturbances that altered the original signal. To eliminate the negative effects of inter symbol interference (ISI), an equalizer was used at the level of the receiver. Practically, two types of equalizers were used: zero forcing (ZF) and minimum mean square error (MMSE), considering the case of perfect channel estimation and the case of estimation using the least square algorithm. The performance measure used was the modification of the bit error rate compared to a given signal to noise ratio; in this sense, the MMSE equalizer offered a higher performance than the ZF equalizer. The aspect of channel equalization considered here is not novel, but there have been very few works that dealt with equalization in the context of the use of turbo codes, especially LDPC codes and polar codes for channel coding. In this respect, this research can be considered a contribution to the field of digital communications.
This study offers a comparative analysis on the LDPC (Low Density Parity Check) codes and Polar codes regarding their efficiency and gives a brief explanation of these error correcting codes. Determining the efficacy of these codes was achieved analyzing BER (Bit Error Rate) towards SNR (Signal to Noise Ratio) making use of Binary Phase Shift Keying (BPSK) in AWGN channel (Additive White Gaussian Noise).
In this article we present an iterative system of equalization and decoding to manage the intersymbol interference over an additive white Gaussian noise (AWGN) channel. Following the classic turbo equalization scheme, the proposed system consists of low-density parity-check (LDPC) coding at the transmitter side; we applied a Log maximum a posteriori probability (Log-MAP) equalizer and min-sum LDPC decoding at the receiver side. The equalizer and decoder, linked through interleaving and deinterleaving, iteratively update each other’s information. We performed the performance analysis of the proposed system, bit error rate (BER) vs. signal-to-noise ratio (SNR), considering three different impulse responses of the channel (h). Our experimental results indicated that increasing the number of iterations performed by the LDPC decoder from 10 to 20 during the iterative process of equalization and decoding leads to better outcomes. The proposed system was compared with turbo equalization and separate equalization, performed before the decoding process with minimum mean-square error (MMSE) and LDPC decoding, in terms of BER vs. SNR, considering the three different h. Based on the analyzed results, it can be concluded that the equalization performance depends on both the impulse responses of the channel and the chosen decoding and equalization method; therefore, the equalization method does not always offer good results for any h.
In this paper, new schemes have been proposed for the estimation of the additive white Gaussian noise (AWGN) channel with intersymbol interference (ISI) in an iterative equalization and decoding system using low-density parity check (LDPC) codes. This article explores the use of the least squares algorithm in various scenarios. For example, the impulse response of the AWGN channel h was initially estimated using a training sequence. Subsequently, the impulse response was calculated based on the training sequence and then re-estimated once using the sequence estimated from the output of the LDPC decoder. Lastly, the impulse response was calculated based on the training sequence and re-estimated twice using the sequence estimated from the output of the LDPC decoder. Comparisons were made between the performances of the three mentioned situations, with the situation in which a perfect estimate of the impulse response of the channel is assumed. The performance analysis focused on how the bit error rate changes in relation to the signal-to-noise ratio. The BER performance comes close to the scenario of having a perfect estimate of the impulse response when the estimation is performed based on the training sequence and then re-estimated twice from the sequence obtained from the output of the LDPC decoder.
30 December 2013 in International Journal of Computers Communications & Control
Typically, gene expression data are formed by thousands of genes associated to tens or hundreds of samples. Gene expression data comprise relevant (discriminant)information as well as irrelevant information often interpreted as noise. The irrelevant information usually affects the efficiency of discovering and grouping meaningful latent information correlated to biological significance, process closely related to data clustering. Class discovery through clustering may help in identifying latent features that reflect molecular signatures, ultimately leading to class forming. One solution for improving the class discovery efficiency is provided by data dimensionality reduction, where data is decomposed into lower dimensional factors, so that those factors approximate original data.
Accurate channel state information (CSI) is essential for reliable orthogonal frequency division multiplexing (OFDM) transmissions, especially when training resources are limited and iterative receiver processing is employed. This paper revisits least squares (LS) and minimum mean square error (MMSE) channel estimation based on training sequences and analyzes their impact on an iterative turbo receiver framework. The initial channel estimate is obtained from an OFDM training transmission, while subsequent refinement is performed using soft information generated by a soft-input soft-output (SISO) equalizer and decoder. Unlike conventional approaches that keep the channel estimate fixed after the training phase, the proposed architecture enables decision-directed channel refinement using reconstructed transmit symbols. The OFDM stage is employed for channel estimation, whereas BER performance is evaluated using independently generated turbo-coded BPSK sequences transmitted through the analyzed channel. The performance analysis investigates the influence of training sequence length and signal-to-noise ratio (SNR) on iterative estimation gains. Simulation results show that, for short training sequences, the proposed iterative strategies can significantly improve BER performance compared with conventional non-iterative LS and MMSE estimators. These results provide practical insights for the design of training-efficient OFDM-based communication systems.