Water scarcity and emerging demands for renewable energy have increased concerns about energy security and advanced wastewater treatment, and microalgae have emerged as promising candidates to solve these problems. This study assesses the feasibility of microalgal wastewater treatment, and the utilization of the resulting microalgal biomass, as a renewable energy source. We cultured four selected microalgal species in filtered wastewater collected from the municipal treatment facility in Daegu, Republic of Korea. We measured nutrient consumption, growth rate, and physicochemical properties during cultivation, then analyzed the biomass for biochemical composition, ultimate analysis, proximate analysis, and biodiesel and lubricant properties, to estimate its potential applications. Desmodesmus sp. KNUA024 emerged as the most promising strain, removing 99.10% of ammonia nitrogen, 91.31% of total nitrogen, and 95.67% of total phosphate. Its biomass had a calorific value of 19.5 MJ kg−1, similar to terrestrial plants. α-linolenic acid was the most abundant polyunsaturated fatty acid (PUFA; 54.83%). Due to its PUFA content, Desmodesmus sp. KNUA024 also had a high iodine value, indicating its potential for use as a bio-lubricant. Therefore, Desmodesmus sp. KNUA024 shows promise for wastewater treatment, energy, and industrial applications.
A cold-tolerant unicellular green alga was isolated from a meltwater stream on King George Island, Antarctica. Morphological, molecular, and biochemical analyses revealed that the isolate belonged to the species Chlorella vulgaris. We tentatively named this algal strain C.vulgaris KNUA007 and investigated its growth and lipid composition. We found that the strain was able to thrive in a wide range of temperatures, from 5 to 30 °C; however, it did not survive at 35 °C. Ultimate analysis confirmed high gross calorific values only at low temperatures (10 °C), with comparable values to land plants for biomass fuel. Gas chromatography/mass spectrometry analysis revealed that the isolate was rich in nutritionally important polyunsaturated fatty acids (PUFAs). The major fatty acid components were hexadecatrienoic acid (C16:3 ω3, 17.31%), linoleic acid (C18:2 ω6, 8.52%), and α-linolenic acid (C18:3 ω3, 43.35%) at 10 °C. The microalga was tolerant to low temperatures, making it an attractive candidate for the production of biochemicals under cold weather conditions. Therefore, this Antarctic microalga may have potential as an alternative to fish and/or plant oils as a source of omega-3 PUFA. The temperature tolerance and composition of C.vulgaris KNUA007 also make the isolate desirable for commercial applications in the pharmaceutical industry.
17 January 2017 in Journal of Ecology and Environment
Species in the heterokont genus Synura are colonial and have silica scales whose ultrastructural characteristics are used for classification. We examined the ultrastructure of silica scales and molecular data (nuclear SSU rDNA and LSU rDNA, and plastid rbcL sequences) to better understand the taxonomy and phylogeny within the section Petersenianae of genus Synura. In addition, we report the first finding of newly recorded Synura species from Korea. We identified all species by examination of scale ultrastructure using scanning and transmission electron microscopy (SEM and TEM). Three newly recorded species from Korea, Synura americana, Synura conopea, and Synura truttae were described based on morphological characters, such as cell size, scale shape, scale size, keel shape, number of struts, distance between struts, degree of interconnections between struts, size of base plate pores, keel pores, base plate hole, and posterior rim. The scales of the newly recorded species, which belong to the section Petersenianae, have a well-developed keel and a characteristic number of struts on the base plate. We performed molecular phylogenetic analyses based on sequence data from three genes in 32 strains (including three outgroup species). The results provided strong statistical support that the section Petersenianae was monophyletic, and that all taxa within this section had well-developed keels and a defined number of struts on the base plate. The phylogenetic tree based on sequence data of three genes was congruent with the data on scale ultrastructure. The resulting phylogenetic tree strongly supported the existence of the section Petersenianae. In addition, we propose newly recorded Synura species from Korea based on phylogenetic analyses and morphological characters: S. americana, S. conopea, and S. truttae.
The study of microalgal communities is critical for understanding aquatic ecosystems. These communities primarily comprise diatoms (Heterokontophyta), with two methods commonly used to study them: Microscopy and metabarcoding. However, these two methods often deliver different results; thus, their suitability for analyzing diatom communities is frequently debated and evaluated. This study used these two methods to analyze the diatom communities in identical water samples and compare the results. The taxonomy of the species constituting the diatom communities was confirmed, and both methods showed that species belonging to the orders Bacillariales and Naviculales (class Bacillariophyceae) are the most diverse. In the lower taxonomic levels (family, genus, and species), microscopy tended to show a bias toward detecting diatom species (Nitzschia frustulum, Nitzschia inconspicua, Nitzschia intermedia, Navicula gregaria, Navicula perminuta, Navicula recens, Navicula sp.) belonging to the Bacillariaceae and Naviculaceae families. The results of the two methods differed in identifying diatom species in the communities and analyzing their structural characteristics. These results are consistent with the fact that diatoms belonging to the genera Nitzschia and Navicula are abundant in the communities; furthermore, only the Illumina MiSeq data showed the abundance of the Melosira and Entomoneis genera. The results obtained from microscopy were superior to those of Illumina MiSeq regarding species-level identification. Based on the results obtained via microscopy and Illumina MiSeq, it was revealed that neither method is perfect and that each has clear strengths and weaknesses. Therefore, to analyze diatom communities effectively and accurately, these two methods should be combined.