To reduce the smoke and nitrogen oxide (NOx) emissions; a detailed study concerned with exhaust gas recirculation (EGR) and diesel injection strategy was conducted on a two-stage series turbocharging diesel engine under transient operating condition. One transient process based on the constant speed of 1650 r/min and load increases linearly from 10% to 100% within 5 s was tested in this study. The effect of the EGR valve control strategy on engine transient performance was examined. The results show that better air-fuel mixing quality can be obtained with the optimized the EGR valve open loop control strategy and the smoke opacity peak decreased more than 64%. Under the EGR valve close loop control strategy; the smoke opacity peak was lower than with open loop control strategy; but higher than without EGR. The effect of fuel injection strategy on engine transient performance was examined with the EGR valve close loop control. The results show that sectional-stage rail pressure (SSRP) strategy (increasing injection pressure from a turning point load to 100% load) and optimizing fuel injection timing can improve the engine emission performance. The satisfactory results can be obtained with lower NOx (382 ppm) emissions and the smoke opacity peak (3.8%), when the turning point load is set to 60% with the injection timing delay 6° CA.

Targeting the performance optimization of an automotive diesel engine under transient operation conditions, in this research, the effect of several non-linear loading strategies on diesel performance have been experimentally analyzed using a heavy-duty turbocharged diesel engine running under transient conditions based on the constant 1650 r/min speed, the load is increased from 10% to 100% in a 5 s transition time The results show that the larger the early loading rate and change point load, the better the dynamic torque response. The peak values of smoke and CO and the transient average of brake specific fuel consumption (BSFC), soot and CO can be decreased by increasing the early loading rate by the loading strategies with the appropriate change point load during transient operation. However, combustion deteriorates under the loading process with an overlarge change point load, causing emissions to increase, and the larger the early loading rate, the worse the worsening. Based on the trade-off consisting of torque dynamic response, transient total and transient average of the BSFC and brake specific emissions, peak values of smoke and CO emissions, it is concluded that the loading strategy with the early loading rate is the 50% load per second and the change point load in the 25% load is the most suitable in these strategies.

The influence of loading strategies on combustion and emissions parameters is experimentally and numerically studied under typical 5 s transient conditions of constant speed and increasing torque. The experiment is conducted on a two-stage turbocharged heavy-duty diesel engine with a constant opening valve high-pressure exhaust gas recirculation (EGR) system. The test results show that: compared with the full-stage loading (FSL) strategy (constant loading rate during the entire transient process), the sectional-stage loading (SSL) strategies (holding a certain time at 50% load) can significantly reduce soot emissions (by 41.3%); the greater the first-stage loading rate, the better the torque response performance, which maximally increases by 56.7%. Besides, longer loading holding time can effectively restrain the overshoot of EGR rate and advance the combustion phase (CA10, CA50) at medium and large loads. However, the larger second-stage loading rate slightly deteriorates the combustion and emission performance. This deterioration situation can be markedly suppressed by adopting a suitable loading hold time.