Permittivity at microwave frequencies determines the practical applications of microwave dielectric ceramics. The accuracy and universality of the permittivity prediction by Clausius–Mossotti equation depends on the dielectric polarizability (αD) database. The most influential αDdatabase put forward by Shannon is facing three challenges in the 5 G era: (1) Few data, (2) Simplistic relation and (3) Low frequency (kHz–MHz) oriented. Here, we optimized and extended the Shannon’s database for microwave frequencies by the four-stage multiple linear regression and support vector machine model. In comparison with the conventional database, the optimized and extended databases achieved higher accuracy and expanded the amount of data from 60 to more than 900. Besides, we analyzed the relationships between αDand ion characteristics, including ionic radius (IR), atomic number (N), valence state (V) and coordination number (CN). We found that the positive cubic law of “αD ~ IR3” discussed in Shannon’s work was valid for the IR changed by the N, but invalid for the change caused by the CN.
In the present work, a wireless microfluidic sensor based on low-temperature cofired ceramic (LTCC) technology for real-time detection of metal ions in water is proposed. The wireless sensor is composed of a planar spiral inductor and parallel plate capacitor (LC) resonant antenna, which integrates with the microchannel in the LTCC substrate between the capacitor plates. Aqueous solutions of Pb(NO3)2, Cd(NO3)2, Mg(NO3)2, Ca(NO3)2, NaNO3, and KNO3 with concentrations of 0–100 mM were tested with the sensors. The metal ion and its concentration in water can be tested by the amplitude of the reflection coefficient (S11) and the resonance frequency (fr) of the wireless microfluidic sensor. The metal ion species can be distinguished from the wireless response behavior of the sensor. The detection limit of the sensor for the selected metal ionic solutions could reach as low as 5 μM. The normalized sensitivity of the sensor is 0.47%, which is higher than that of the reported liquid microfluidic sensors based on microwave resonators. The wireless microfluidic sensor of this study is promising for rapid and convenient detection of heavy metal ion pollutants in the industrial wastewater.
9 April 2021 in ACS Applied Materials & Interfaces
This work reports a novel wireless microfluidic biosensor based on low temperature co-fired ceramic (LTCC) technology. The wireless biosensor consists of a planar spiral inductor and parallel plate capacitor (LC) resonant antenna, which integrates with microchannel bends in the LTCC substrate. The wireless response of the biosensor was associated to the changes of its resonant frequency due to the alteration in the permittivity of the liquid flow in the microchannel. The wireless sensing performance to different organic liquids with permittivity from 3 to 78.5 was presented. The measured results are in good agreement with the theoretical calculation. The wireless detection for the concentration of glucose in water solution was investigated, and an excellent linear response and repeatability were obtained. This kind of LC wireless microfluidic sensor is very promising in establishing wireless lab-on-a-chip for biomedical and chemical applications.
Tin(II) monosulfide (SnS) nanosheets were synthesized using SnCl4•5H2O and S powders as raw materials in the presence of H2O via a facile chemical bath method. Orthorhombic phase SnS nanosheets with a thickness of ~100 nm and lateral dimensions of 2~10 μm were obtained by controlling the synthesis parameters. The formation of a SnO2 intermediate is key to the valence reduction of Sn ions (from IV to II) and the formation of SnS. The gas sensors fabricated from SnS nanosheets exhibited an excellent response of 14.86 to 100 ppm ethanol vapor when operating at 160 °C, as well as fast response and recovery times of 23 s and 26 s, respectively. The sensors showed excellent selectivity for the detection of ethanol over acetone, methanol, and ammonia gases, which indicates the SnS nanosheets are promising for high-performance ethanol gas sensing applications.