Han-Youl Ryu

Prof. Han-Youl Ryu

Inha University
orcid

Research Focus & Metrics

Academic Career Length

27Years (2000-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
24 August 2009 in Applied Physics Letters
Verified
Journal Article
Closed access
HRHan-Youl Ryu
Han-Youl Ryu
HKHyun-Sung Kim
Hyun-Sung Kim
JSJong-In Shim
Jong-In Shim
Efficiency droop in InGaN light-emitting diodes (LEDs) is analyzed based on the rate equation model. By using the peak point of the efficiency versus current-density relation as the parameters of the rate equation analysis, internal quantum efficiency and each recombination current at arbitrary current density can be unambiguously determined without any knowledge of A, B, and C coefficients. The theoretical analysis is compared with measured efficiency of a LED sample and good agreement between the model and experiment is found. The investigation of recombination coefficients shows that Auger recombination alone is not sufficient to explain the efficiency droop of InGaN LEDs.

26 March 2012 in Applied Physics Letters
Verified
Journal Article
Closed access
HRHan-Youl Ryu
Han-Youl Ryu
Dong-Soo ShinDong-Soo Shin
Dong-Soo Shin
JSJong-In Shim
Jong-In Shim
In InGaN quantum wells (QWs), effective active volume can be greatly reduced due to carrier localization in In-rich region and inhomogeneous carrier distribution. The authors investigate the efficiency droop of InGaN-based light-emitting diodes (LEDs) based on the carrier rate equation including the influence of the reduced effective active volume. It is found that efficiency droop characteristics can be modeled well without employing a large Auger recombination coefficient by assuming that only a small portion of the QWs is effectively used as active region. The presented model is expected to provide insight into the realization of droop-free operation in nitride LEDs.

4 February 2014 in Discover Nano
Verified
Journal Article
Open access
PDF file
HRHan-Youl Ryu
Han-Youl Ryu
Light extraction efficiency (LEE) of AlGaN-based nanorod deep ultraviolet (UV) light-emitting diodes (LEDs) is numerically investigated using three-dimensional finite-difference time-domain simulations. LEE of deep UV LEDs is limited by strong light absorption in the p-GaN contact layer and total internal reflection. The nanorod structure is found to be quite effective in increasing LEE of deep UV LEDs especially for the transverse magnetic (TM) mode. In the nanorod LED, strong dependence of LEE on structural parameters such as the diameter of a nanorod and the p-GaN thickness is observed, which can be attributed to the formation of resonant modes inside the nanorod structure. Simulation results show that, when the structural parameters of the nanorod LED are optimized, LEE can be higher than 50% and 60% for the transverse electric (TE) and TM modes, respectively. The nanorod structure is expected to be a good candidate for the application to future high-efficiency deep UV LEDs.

12 April 2017 in Scientific Reports
Verified
Journal Article
Open access
PDF file
HRHan-Youl Ryu
Han-Youl Ryu
KJK. S. Jeon
K. S. Jeon
MKM. G. Kang
M. G. Kang
HYH. K. Yuh
H. K. Yuh
YCY. H. Choi
Y. H. Choi
JLJ. S. Lee
J. S. Lee
We investigated the efficiency droop and polarization-induced internal electric field of InGaN blue light-emitting diodes (LEDs) grown on silicon(111) and c-plane sapphire substrates. The efficiency droop of the LED sample grown on silicon substrates was considerably lower than that of the identically fabricated LED sample grown on sapphire substrates. Consequently, the LED on silicon showed higher efficiency at a sufficiently high injection current despite the lower peak efficiency caused by the poorer crystal quality. The reduced efficiency droop for the LED on silicon was attributed to its lower internal electric field, which was confirmed by reverse-bias electro-reflectance measurements and numerical simulations. The internal electric field of the multiple quantum wells (MQWs) on silicon was found to be reduced by more than 40% compared to that of the MQWs on sapphire, which resulted in a more homogenous carrier distribution in InGaN MQWs, lower Auger recombination rates, and consequently reduced efficiency droop for the LEDs grown on the silicon substrates. Owing to its greatly reduced efficiency droop, the InGaN blue LED on silicon substrates is expected to be a good cost effective solution for future lighting technology.

1 September 2020 in Optics Express
Verified
Journal Article
Closed access
HRHan-Youl Ryu
Han-Youl Ryu
GRGeun-Hwan Ryu
Geun-Hwan Ryu
COChibuzo Onwukaeme
Chibuzo Onwukaeme
BMByongjin Ma
Byongjin Ma
This study investigated the temperature dependence of the Auger recombination coefficient (C) in an InGaN/GaN blue multiple-quantum-well (MQW) light-emitting diode structure at temperatures between 20 and 100°C. The temperature dependence of C was determined by fitting the measured external quantum efficiency (EQE) data using an analytical model or numerical simulation. In the analytical model, the carrier density in InGaN MQWs was assumed to be constant and independent of temperature. In contrast, the inhomogeneous carrier distribution in MQWs and its temperature-dependent redistribution were included in the numerical simulation. When the analytical model was employed to fit the EQE curve, C decreased with increasing temperature. On the other hand, when the numerical simulation was employed, C increased steadily by ∼31% as the temperature was increased from 20 to 100°C. We found that the temperature-dependent carrier distribution is important to consider when determining the temperature dependence of the Auger recombination coefficient in InGaN MQW structures.

8 January 2013 in Optics Express
Verified
Journal Article
Closed access
PDF file
HRHan-Youl Ryu
Han-Youl Ryu
KJKi-Seong Jeon
Ki-Seong Jeon
MKMin-Goo Kang
Min-Goo Kang
YCYunho Choi
Yunho Choi
JLJeong-Soo Lee
Jeong-Soo Lee
We investigate the dependence of various efficiencies in GaN-based vertical blue light-emitting diode (LED) structures on the thickness and doping concentration of the n-GaN layer by using numerical simulations. The electrical efficiency (EE) and the internal quantum efficiency (IQE) are found to increase as the thickness or doping concentration increases due to the improvement of current spreading. On the contrary, the light extraction efficiency (LEE) decreases with increasing doping concentration or n-GaN thickness by the free-carrier absorption. By combining the results of EE, IQE, and LEE, wall-plug efficiency (WPE) of the vertical LED is calculated, and the optimum thickness and doping concentration of the n-GaN layer is found for obtaining the maximum WPE.