Yaowen Zhang

Dr. Yaowen Zhang

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 April 2024 in Physics of Fluids
Verified
Journal Article
Closed access
PDF file
YZYaowen Zhang
Yaowen Zhang
XYXicai Yan
Xicai Yan
YLYong Li
Yong Li
Suppression of vortex–airfoil interaction noise from a rod-airfoil model by virtual serrations and surface morphing formed by the leading-edge (LE) blowing was investigated experimentally in an anechoic wind tunnel. The control efficiency of the virtual serrations and surface morphing was evaluated and analyzed by setting different air flow rates (Q), deflection angles (α), and orifice number (M). Noise measurements by far-field microphones show that both can effectively reduce the peak tonal noise generated by the vortex–airfoil interaction, with the control efficiency increasing with the increment of flow rate Q. As for the LE serration, the noise reduction increases with the virtual serration amplitude ratio Av (=Ub/U∞, Ub: blowing velocity; U∞: wind speed), but decreases slightly with the deflection angle α. A reduction of 12–14 dB is obtained when Av = 3.7 and α = 0° or 10°, and there exists a critical amplitude of Av = 1.5, under which no noise reduction is achieved. Compared to the serration at the same flow condition, the virtual surface morphing has much lower control efficiency, with a maximum noise reduction of 3–5 dB. The flow visualization by the particle image velocimetry technique reveals that both build buffer zones in the front of the airfoil LE, preventing the vortices from directly impinging upon the solid LE, thus reducing the intensity of vortex–airfoil interaction. In particular, the virtual serration breaks up the large-scale vortex structure into small-scale vortices, manifesting its high noise control efficiency.

25 January 2025 in Aerospace
Verified
Journal Article
Open access
PDF file
YZYaowen Zhang
Yaowen Zhang
WWwang shaozhan Wang
wang shaozhan Wang
DYDangguo YANG
Dangguo YANG
BDBin Dong
Bin Dong
Suction is an important control method in the shock wave and boundary layer interaction (SWBLI). Aimed at the problem of separation bubbles induced at the expansion corners, this study investigates the influence of suction on both the dimensions of bubble and the structure of the flow field at varying positions and back pressures under Ma = 2.73. As the upstream suction hole moves to the shoulder point, the size of the separation bubble decreases slightly. The decrease in back pressure leads to an increase in flow deflection angle αh. The low-kinetic-energy fluid in the boundary layer is removed and the thickness of the boundary layer decreases. Suction downstream of the shoulder point leads to an obvious change in separation bubble size. When the bleed position is upstream of the actual location of incident shock (Ddown = 2δ), the separation zone is located at the trailing edge of the hole, and the convergence of the separation shock wave (SS) and the barrier shock wave (BSW) leads to a large increase in the pressure plateau. At the downstream of the incident shock (Ddown = 5δ), the separation zone is situated at the leading edge of the hole, resulting in a substantial reduction in the size of the separation bubble. The flow reaches 88.5% of the theoretical expansion value at the shoulder point and directly turns into the bleeding area at the leeward side of the separation bubble. The deflection angle αh reaches the maximum of 46°, and the sonic flow coefficient Qsonic increases significantly. At the theoretical incident shock position (Ddown = 7δ), the separation zone is far from the suction hole position; the two are almost decoupled. The size of the bubble increases rapidly and the reattachment shock wave (RS) appears.