The shuttling of polyiodides and sluggish redox kinetics greatly hinder the implementation of an aqueous Zn-I2 battery. Despite numerous catalysts have been implemented to improve the iodine cathode stability, an important aspect, the balance between polyiodide adsorption and interfacial mass transport kinetics at the cathode surface, has been overlooked. It is known that insufficient intermediate trapping ability will cause low iodine utilization and fast capacity decay. However, excessive adsorption of iodine species will block the ion transport and lead to passivation of the catalyst, which is particularly serious under lean-electrolyte and high mass loading conditions. To tackle this challenge, we employ a dual single atomic catalyst encompassing NiN4P and FeN4P sites to promote a catalytic interface with well-balanced solvophilicity and iodophilicity. Specifically, the FeN4 and NiN4 sites primarily enhance polyiodide immobilization and mass transport, respectively. The P ligands further strengthen these functions by tuning the Fe site from low to medium spin state and creating the anion-rich inner Helmholtz plane at Ni sites. Benefiting from this dual-metal atomic catalyst, the iodine cathode exhibits high cycling stability and ultralow self-discharge rate under a low E/I ratio. This work provides insights into regulating the aqueous halogen cathode interface for long cycle life.
12 October 2022 in ACS Applied Materials & Interfaces
Practical application of surface-enhanced Raman spectroscopy (SERS) is greatly limited by the inaccurate quantitative analyses due to the measuring parameter’s fluctuations induced by different operators, different Raman spectrometers, and different test sites and moments, especially during the field tests. Herein, we develop a strategy of quantitative SERS for field detection via designing structurally homogeneous and ordered Ag-coated Si nanocone arrays. Such an array is fabricated as SERS chips by depositing Ag on the template etching-induced Si nanocone array. Taking 4-aminothiophenol as the typical analyte, the influences of fluctuations in measuring parameters (such as defocusing depth and laser powers) on Raman signals are systematically studied, which significantly change SERS measurements. It has been shown that the silicon underneath the Ag coating in the chip can respond to the measuring parameters’ fluctuations synchronously with and similar to the analyte adsorbed on the chip surface, and the normalization with Si Raman signals can well eliminate the big fluctuations (up to 1 or 2 orders of magnitude) in measurements, achieving highly reproducible measurements (mostly, <5% in signal fluctuations) and accurate quantitative SERS analyses. Finally, the simulated field tests demonstrate that the developed strategy enables quantitatively analyzing the highly scattered SERS measurements well with 1 order of magnitude in signal fluctuation, exhibiting good practicability. This study provides a new practical chip and reliable quantitative SERS for the field detection of real samples.
Detection of trace harmful small gaseous molecules (h-SGMs), based on surface enhanced Raman spectroscopy (SERS), has been expected to be a useful strategy but is challenging due to the extremely small Raman cross section (RCS) and weak metal affinity of the h-SGMs. Here, a new strategy, ultrathin layer solid transformation-enabled (ULSTE)-SERS, is proposed. It uses the chemical reaction between the target h-SGM and an ultrathin layer of solid sensing matter coated on a plasmonic metal SERS substrate. This reaction in situ produces a new solid matter with large RCS, which ensures the detection of trace h-SGMs via SERS. The validity of this strategy has been demonstrated by detecting trace H2S gas with an ultrathin CuO layer wrapped around Au nanoparticles. Furthermore, this strategy allows fast and ultrasensitive detection. The detection limit can be down to ppb (even ppt) levels with 10 min preprocessing. Importantly, this strategy has good universality for various other h-SGMs, such as SO2, CS2, CH3SH, and HCl, etc., using appropriate sensing matter. Additionally, the ULSTE-SERS is also suitable for unstable molecules and fast portable detection due to the stable solid layer. This work provides highly efficient SERS-based detection of trace h-SGMs, which is easily applied in practical situations.