The combined effects of thermal and cyclic loading result in complex mechanical behavior in engineering rock masses. The study of the physical and mechanical properties of these rock masses is of great importance for improving the stability and sustainability of structures built on thermally treated rock masses. In order to understand the failure mechanism, uniaxial compression tests and cyclic loading and unloading tests were conducted on granite specimens that had undergone thermal treatment at various temperatures. The test results indicate that the density and P-wave velocity of the specimens decrease while the degree of damage increases after thermal treatment. The compressive strength and elastic modulus of the specimens generally decrease as a result of thermal treatment, although thermal hardening does occur within the temperature range of 200–400 °C. The dilatancy characteristics of the specimens change with the treatment temperature, and they are more prone to shear dilation under external loading. Furthermore, the failure mode of the specimens transitions from brittle to ductile failure as the treatment temperature increases. The combination of thermal treatment and cyclic loading causes the rock fragments to become looser and finer following specimen failure.
Since 2020, with the global spread of major respiratory infectious diseases, such as COVID–19, the demand and consumption of personal protective equipment, such as masks, have increased dramatically worldwide. The environmental pollution caused by numerous waste disposable face masks has gradually attracted people’s attention. In this study, the mechanical properties of mask–chip–reinforced soil are evaluated from a new perspective, through the uniaxial, biaxial, conventional triaxial, and true triaxial compression tests on reshaped sandy soil samples mixed with different contents of mask chips. The experimental results show that the mechanical properties of the sandy soil can be improved by the mask chips. With the proper content of mask chips, the failure strength is substantially improved, and the failure of soil is delayed. Meanwhile, the strength and stiffness are significantly affected by the stress path and the content of mask chips, even if the soil samples with the same mask–chip content can also show different mechanical properties under different stress paths. Additionally, the mechanical properties of soil are not necessarily improved constantly with the increasing content of mask chips. The failure strength of sandy soil samples under conventional and true triaxial stress paths decreases when the mass content of mask chips exceeds 0.3% and 0.5%, respectively. This study confirms the potential of mask chips applied to subgrade, slope, and other engineering construction fields in a sustainable way.
Transversely isotropic rocks, which are special anisotropic materials, are widely encountered in civil, mining, petroleum, geothermal, and radioactive waste-disposal engineering. Rock is frequently subject to cyclic loads resulting from natural and human-caused events. However, to date, the fracture mechanism of transversely isotropic rocks under cyclic loading remains poorly understood. To address this gap, uniaxial monotonic-loading and cyclic-loading tests were performed on slate specimens by the MTS815 system, during which acoustic emission (AE) signals inside the rock were monitored, and finally the fracture surfaces of the tested rock were scanned by scanning electron microscopy (SEM). Through these tests, the anisotropic mechanical properties, damage evolution, AE characteristics and fracture pattern of slate as a transversely isotropic rock were studied. The results show that the peak strength of specimens varies with the loading–foliation angle under monotonic and cyclic loading, following a U-shaped trend. The deformation modulus during unloading is more capable of characterizing the damage inside the specimen than that during loading. By defining the damage degree based on dissipation energy, it is found that the damage variable is influenced by the loading–foliation angle and the cyclic stress step. The AE characteristics of specimens exhibit significant anisotropy, closely correlated to the loading condition and loading–foliation angle. Regardless of cyclic stress step, the AE counts of specimens with a loading–foliation angle of 0° are mainly distributed near the peak region, whereas those of specimens with other loading–foliation angles occur primarily in the early stage of each cyclic loading. Finally, it is revealed that the fracture mechanism of slate specimens is determined by the loading–foliation angle, loading condition, and cyclic stress step.