Piotr Woźniak

Mr. Piotr Woźniak

orcid

Research Focus & Metrics

Academic Career Length

4Years (2023-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 January 2024 in Membranes
Verified
Journal Article
Open access
PDF file
Marek GrytaMarek Gryta
Marek Gryta
PWPiotr Woźniak
Piotr Woźniak
Polyethersulfone (PES) is a polymer popularly used to produce ultrafiltration (UF) membranes. PES is relatively hydrophobic; thus, hydrophilic ingredients are added to the membrane matrix to reduce the fouling intensity. Ingredients such as polyvinylpyrrolidone (PVP) reduce the resistance of PES to NaOH solutions. This study investigated the possibility of using PES membranes for the separation of alkaline cleaning solutions. For this purpose, self-made PES membranes and commercial ultrafiltration PES membranes (UE10—10 kDa and UE50—100 kDa) containing PVP additive were used. The membranes were soaked for 18 months in alkaline (pH = 11.3–11.5) solutions of car washing fluids. It has been found that long-term contact with these solutions caused changes in the structure of the surface layer, especially of membranes containing PVP. As a result, the separation of dextran (100–200 kDa) decreased by 30–40% for PES membranes, 30–40% for UE10 and 40–60% for UE50. Despite these changes, the separation efficiency (rejection of COD, NTU and anionic surfactants) of synthetic car wash wastewater (mixture of surfactants and hydrowax) was similar to the results obtained for pristine membranes.

28 September 2024 in Membranes
Verified
Journal Article
Open access
PDF file
PWPiotr Woźniak
Piotr Woźniak
Marek GrytaMarek Gryta
Marek Gryta
The commercial ultrafiltration tubular polyvinylidene fluoride (PVDF) (100 and 200 kDa) and polyethersulfone (PES) (4 kDa) membranes were applied for filtration of car wash wastewater. Intensive fouling was noticed, which caused an over 50% flux reduction during 3–5 h of the filtration process. This phenomenon was reduced by washing the membranes with an alkaline cleaning agent (pH = 11.5), which is used in car washes to remove insects. The filtration/membrane washing cycle was repeated many times to achieve stable operation of the membrane modules. It has been found that cyclic repeated washing did not deteriorate the performance of the membranes. Despite frequent cleaning of the membranes (every 5–7 h), irreversible fouling occurred, resulting in a 20% reduction in the initial permeate flux. However, the formation of a filter cake definitely improved the separation degree and, for the 200 kDa membranes, separation of the wastewater components was obtained as it was for the 4 kDa membranes, while, at the same time, the permeate flux was 5 times higher.

19 July 2024 in Membranes
Verified
Journal Article
Open access
PDF file
WTWirginia Tomczak
Wirginia Tomczak
PWPiotr Woźniak
Piotr Woźniak
Marek GrytaMarek Gryta
Marek Gryta
JGJoanna Grzechulska-Damszel
Joanna Grzechulska-Damszel
MDMonika Daniluk
Monika Daniluk
Car wash wastewaters (CWWs) contain various pollutants with different contents. Hence, selecting an appropriate process for their treatment is a great challenge. Undoubtedly, the ultrafiltration (UF) process is one of the most interesting and reliable choices. Therefore, the main aim of the current study was to investigate the performance of the UF membranes used for the long-term treatment of real CWWs. For this purpose, two polyethersulfone (PES) membranes with molecular weight cut-off (MWCO) values equal to 10 and 100 kDa were applied. As expected, a significant decrease in the permeate flux during the UF run was observed. However, it was immediately demonstrated that the systematic cleaning of membranes (every day) with Insect agent (pH = 11.5) prevented a further decline in the process’s performance. In addition, this study focused on the relative flux during the process run with breaks lasting a few days when the UF installation was filled with distilled water. The results of this research indicated that aqueous media favor microorganism adherence to the surface which leads to the formation of biofilms inside processing installations. As a consequence, many attempts have been made to restore the initial membrane performance. It has been found that the application of several chemical agents is required. More precisely, the use of an Insect solution, P3 Ultrasil 11 agent, and phosphoric acid increases the relative flux to a value of 0.8. Finally, it has been indicated that the membranes used in this work are resistant to the long-term exposure to bacteria and chemical agents. However, during the separation of CWWs for the membrane with an MWCO of 10 kDa, a lesser fouling influence and higher effectiveness of cleaning were obtained. Finally, the present study demonstrates a novel analysis and innovative implications towards applying the UF process for the CWW treatment.

24 May 2024 in Membranes
Verified
Journal Article
Open access
PDF file
Marek GrytaMarek Gryta
Marek Gryta
PWPiotr Woźniak
Piotr Woźniak
Sylwia MoziaSylwia Mozia
Sylwia Mozia
The commercial ultrafiltration polyethersulfone (PES) membranes (10 and 100 kDa) blended with polyvinylpyrrolidone (PVP) were applied for the filtration of car wash wastewater. Periodical membrane rinsing with water did not prevent fouling and a decrease in permeate flux was observed. Fouling was reduced by washing the membranes with cleaning agents, which are used in car washes to clean wheels and remove insects. In addition to surfactants, these agents contain NaOH, hence the pH value of cleaning solutions was over 11. Long-term contact with such solutions resulted in the removal of PVP from the membrane matrix and an increase in pore size. The PES membranes were soaked in an alkaline solution (pH = 11.5) for 20 months, after which the 200 kDa dextran rejection decreased from 95% to 80%. To compare with the static degradation conditions, 8 weeks of alkaline agent filtration was realized, after which the dextran (200 kDa) rejection decreased below 50%. This indicated that the cross-flow of alkaline agents can accelerate the removal of components building the membrane matrix. Despite membrane degradation, the separation efficiency (the rejection of chemical oxygen demand—COD, turbidity, and surfactants) during the treatment of synthetic car wash wastewater was similar to that obtained for pristine membranes.

8 January 2023 in Membranes
Verified
Journal Article
Open access
PDF file
PWPiotr Woźniak
Piotr Woźniak
Marek GrytaMarek Gryta
Marek Gryta
In the present study, the membrane distillation (MD) process was studied with the use of commercial polytetrafluoroethylene (PTFE) capillary membranes. For this purpose, both solutions with NaCl concentrations up to 300 g/L and brines contaminated with oil (70–120 mg/L) were used as feeds. The membrane’s wetting resistance was tested by conducting long-term experiments for over 3500 h. Using detailed studies, it has been shown that increasing the salt concentration from 35 to 300 g/L resulted in a 50% reduction in the permeate flux. Nevertheless, the membranes retained 100% of the salt rejection after 2000 h of the module’s operation. Moreover, it has been found that performing the MD process with brines contaminated with oil (120 mg/L) led to the wetting of some membranes pores, which it turn resulted in an increase in the distillate’s conductivity to 450 µS/cm after 700 h running the process. The mechanism of pore wetting by oil droplets adsorbed on the membrane’s surface was presented. Finally, the proposed method of membrane cleaning with the use of a solvent allowed restoring the initial MD module’s performance. Consequently, both the permeate flux and distillate conductivity were stable during the MD of the feed containing 35 g/L of NaCl over the next 280 h.

25 May 2024 in Separations
Verified
Journal Article
Open access
PDF file
PWPiotr Woźniak
Piotr Woźniak
Marek GrytaMarek Gryta
Marek Gryta
In the present study, oily wastewater generated during car washing was separated using ultrafiltration (UF). Wastewater was collected from the settling tank of two manual car washes. In addition to pollutants removed from cars, such wastewater contains surfactants, the impact of which on the process of ultrafiltration has been analyzed. For this purpose, the application of commercial UF polyethersulfone (PES) membranes (10 and 100 kDa) and polyvinylidene fluoride (PVDF) tubular membranes (100 kDa) was comprehensively examined. Almost 100% removal of oil contaminants was achieved; however, intensive fouling was noticed. The membrane morphology and deposit composition were studied using a scanning electron microscope coupled with energy dispersion spectrometry. The fouling phenomenon was reduced by washing the membranes with an alkaline cleaning agent (pH = 11.5), which is used in car washes to remove insects. The filtration/membrane washing cycle was repeated many times to achieve stable operation of the membrane modules. The UF process was carried out for 120–140 h, and the separation efficiency was analyzed based on the rejection of dextrans, COD, BOD, total N and P, turbidity, and anionic surfactants. It has been found that cyclic repeated washing did not deteriorate the membrane’s performance, and a permeate with a turbidity of 0.12–0.35 NTU was obtained. Thus, cleaning agents used for washing cars can also be used for membrane cleaning.