The addition of alkali elements has become mandatory for boosting solar cell performance in chalcogenide thin films based on kesterites (Cu2ZnSnS4, CZTS). A novel doping process is presented here, that consists in the incorporation of sodium or lithium during the deposition of the CdS buffer layer, followed by a post-deposition annealing (PDA). As the doping route leads to more efficient devices in comparison with the undoped reference sample, the influence of PDA temperature was also investigated. Compositional profiling techniques, time-of-flight secondary ion mass spectrometry (TOF-SIMS) and glow discharge optical mission spectroscopy (GDOES), revealed a dependence of the alkaline distribution in kesterites with the PDA temperature. Although the doping process is effective in that it increases the alkaline concentration compared to the undoped sample, the compositional profiles indicate that a significant proportion of Li and Na remains ‘trapped’ within the CdS layer. In the 200 °C–300 °C range the alkali profiles registered the higher concentration inside the kesterite. Despite this, an additional alkali accumulation close to the molybdenum/fluorine doped tin oxide substrate was found for all the samples, which is frequently related to alkali segregation at interfaces. The addition of both, lithium and sodium, improves the photovoltaic response compared to the undoped reference device. This is mainly explained by a substantial improvement in the open-circuit potential (Voc) of the cells, with best devices achieving efficiencies of 4.5% and 3% for lithium and sodium, respectively. Scanning-electron microscopy images depicted a ‘bilayer structure’ with larger grains at the top and small grains at the bottom in all samples. Moreover, the calculated bandgap energies of the CZTS films account for changes in the crystallographic order-disorder of the kesterites, more related to the PDA treatment rather than alkali incorporation. Even if further optimization of the absorber synthesis and doping process will be required, this investigation allowed the evaluation of a novel strategy for alkali incorporation in kesterite based solar cells.
20 April 2013 in Journal of Applied Electrochemistry
The development of sensors that can monitor ultraviolet radiation has many implications for daily life, and even more so if the focus is on low-cost solution processes and the use of eco-friendly materials. In this study, we produced a UV-sensor based on Sn-doped ZnO thin films grown by spray pyrolysis, with a doping content ranging from 1 to 10 at.%. The study focuses on the characterization of the films and the device, and their potential for UV detection. Structural analysis via XRD, FESEM, and STEM confirms the polycrystalline nature of the films, with a hexagonal single-phase wurtzite structure of ZnO. Although the dopant content in the films was widely varied, optoelectronic properties such as transmittance, resistivity, energy gap, density, and carrier mobility are not significantly modified. Sprayed Sn-doped ZnO films demonstrated high sensitivity to ultraviolet light, whether monochromatic or that coming from solar radiation. Outdoor measurements showed promising performance of the UV-sensor, indicating its potential applicability for real-time UV monitoring and potential use. Overall, sprayed Sn-doped ZnO thin films offer a viable and low-cost solution for the fabrication of UV-sensors with desirable properties such as a wide and direct bandgap, high sensitivity, and ease of fabrication.