The solubility of methane in formation water and water content in the coexisting gas phase were measured under the conditions of high temperature and high pressure, using an ultra-high-pressure fluid PVT system, where the experimental temperature reached up to 453 K and pressure reached up to 130 MPa. Experimental results show the following (1) The two phases of gas and liquid still exhibit an obvious interphase interface even under high temperatures and pressures. (2) When temperatures exceed 353 K, the solubility of methane in formation water increases as the temperature and pressure rise. The growth rate of solubility is faster under a relatively low temperature and pressure, and slower at a relatively high temperature and pressure, but the solubility will not increase without limit. In this experiment, the solubility of methane in formation water reached its peak when the temperature was at 453 K and the pressure at 130 MPa. (3) Water content in the coexisting gas phase increases as temperature rises, with a smaller increase at relatively low temperatures and a much greater increase at relatively high temperatures but decreases with the increasing pressure, more rapidly under low pressure and more slowly under high pressure. The solubility of methane in formation water and the water content in the coexisting gas phase are controlled by both temperature and pressure, but using classic calculation models, these two parameters under high temperatures and pressures are inconsistent with our experimental data. Therefore, the study is significant and highlights other possible effects on solubility and condensate water content. Additionally, an example from the Yinggehai Basin in the South China Sea, where the temperature and the pressure are high, demonstrates the influence of solubility and phase behaviour on natural gas migration, its formation and the distribution of gas reservoirs.
18 May 2016 in Australian Journal of Earth Sciences
Recently, a tuffaceous tight oil reservoir with considerable reserves has been found in the Santanghu Basin, northwestern China. The physical properties of the tuff are characterised by high porosity (5–25%) and low permeability (0.01–0.50 mD). This reservoir has the peculiar property of being a sedimentary organic-matter-bearing tuff formed by air-fall volcanic ash in a lake. Its discovery offered an excellent opportunity to further our knowledge of the formation and evolution of tuffaceous tight-reservoir micropores. This study integrates analyses of organic geochemistry, thin-sections, scanning electron microscopy, CT scanning, mineral and element compositions, mercury injections and measurements of porosity and permeability to determine the characteristics of the formation and evolution of the tuff micropores. (1) The tuff reservoir comprises vitric, crystal-vitric, pelitic and silicified tuffs, which are characterised by high porosity and big throat, moderate porosity and thin throat, low porosity and thin throat, and very low porosity and moderate throat pore structures, respectively. (2) Of the four types, vitric tuff has the properties best suited to a reservoir, and devitrification of volcanic glasses is the principal mechanism of reservoir micropore formation. (3) The tuff of the Permian Tiaohu Formation contains sedimentary organic matter, and organic acids produced during kerogen maturation facilitate the process of devitrification. (4) Evolution of tuff porosity depends mainly on the original composition and burial depth. The porosity of vitric tuff is higher than crystal-vitric tuff at the same depth, but both their porosities initially decrease and then increase with depth. At depths >3000 m, vitric tuff retains the trend towards higher porosity, whereas the porosity of crystal-vitric tuff remains largely unchanged or even decreases. The results of this investigation could be considered a reference regarding the distribution and prediction of tuffaceous reservoirs in similar situations in other parts of the world.
As a distinct type of reservoir, tuffaceous tight reservoirs have attracted much attention. However, previous studies on tuffaceous tight reservoirs formed in the burial diagenetic stage are few, particularly regarding the genesis of micropores, which restricts the in-depth exploration of tuffaceous tight oil. According to thin section observation, scanning electron microscopy (SEM) identification, X-ray diffraction (XRD) experiments, elemental analyses, porosity and permeability tests, and pore structure analyses, the micropore characteristics of the Carboniferous tuffaceous tight reservoir formed by burial dissolution in the Santanghu Basin, NW China, are studied. In addition, the cause of the tuff micropore formation and its geological significance are also researched in this paper. The results are as follows: (1) The tuffaceous tight reservoir formed by burial dissolution mainly consists of quartz, feldspar, dolomite, and clay minerals. The reservoir space mainly consists of intergranular pores between minerals, intragranular dissolution pores within feldspars, calcite, dolomite, clay minerals, and locally developed organic matter pores. (2) The formation of micropores in tuff reservoirs formed by burial dissolution is mainly related to the original composition of the tuff. (3) Tuffaceous reservoirs with good physical properties are usually formed at the bottom or top of a large set of source rock. The results of this investigation can provide innovative theoretical evidence for the accumulation mechanism of tuffaceous tight oil formed by burial dissolution. Meanwhile, it can be considered a reference regarding the distribution of and predictions for tuffaceous reservoirs formed by burial dissolution in similar situations in other parts of the world.