Titanium (Ti) is generally considered as an ideal bipolar plate (BPP) material because of its excellent corrosion resistance, good machinability and lightweight nature. However, the easy-passivation property, which leads to increased interfacial contact resistance (ICR) and subsequently decreased cell performance, limits its large-scale commercial application in proton exchange membrane fuel cells (PEMFCs). In this paper, we proposed a NiTi alloy prepared by suction casting as a promising bipolar plate for PEMFCs. This NiTi alloy exhibits significantly decreased ICR values (16.8 mΩ cm2 at 1.4 MPa) compared with pure Ti (88.6 mΩ cm2 at 1.4 MPa), along with enhanced corrosion resistance compared with pure nickel (Ni). The superior corrosion resistance of NiTi alloy is accredited to the nobler open circuit potential and corrosion potential, coupled with low corrosion current densities and passive current densities. The improved ICR can be interpreted by the existence of high-proportioned metallic Ni in the passive film, which contributes to the reduced capacitance characteristic of the passive film (compared with Ti) and enhances charge conduction. This work provides a feasible option to ameliorate BPP material that may have desirable corrosion resistance and ICR.
Proton exchange membrane fuel cells (PEMFCs) have gained increasing interests as promising power sources due to their ability to convert hydrogen and oxygen directly into electricity with high efficiency and zero greenhouse gas emissions. Bipolar plates (BPs) are considered as a critical component of PEMFCs, serving to collect current, separate gases, distribute the flow field, and conduct heat. This paper reviews the technical status and advancements in BP materials, with special focus on strategies for enhancing interfacial contact resistance (ICR) and corrosion resistance through conductive polymer (CP) coatings. First, commonly used BP materials in PEMFCs are summarized. Then, the advantages and limitations of various coatings for metallic BPs are discussed. Finally, recent progress in CP coatings for metallic BPs, aimed at achieving high corrosion resistance and low ICR, is comprehensively reviewed.
The solid oxide electrolyte Li1.5Al0.5Ge1.5(PO4)3 (LAGP) with a NASICON structure has a high bulk ionic conductivity of 10−4 S cm−1 at room temperature and good stability in the air because of the strong P5+-O2− covalence bonding. However, the Ge4+ ions in LAGP are quickly reduced to Ge3+ on contact with the metallic lithium anode, and the LAGP ceramic has insufficient physical contact with the electrodes in all-solid-state batteries, which limits the large-scale application of the LAGP electrolyte in all-solid-state Li-metal batteries. Here, we prepared flexible PEO/LiTFSI/LAGP composite electrolytes, and the introduction of LAGP as a ceramic filler in polymer electrolytes increases the total ionic conductivity and the electrochemical stability of the composite electrolyte. Moreover, the flexible polymer shows good contact with the electrodes, resulting in a small interfacial resistance and stable cycling of all-solid-state Li-metal batteries. The influence of the external pressure and temperature on Li+ transfer across the Li/electrolyte interface is also investigated.