A detailed urban parameterization scheme is used in and above a street canyon. To validate this new scheme, the model is run offline on a vertical column (one-dimensional simulations), using measurements from a 30-m-high tower for upper boundary conditions. Measurements were obtained during the intensive observation period of the Basel Urban Boundary Layer Experiment (BUBBLE). Vertical profiles of meteorological variables are simulated in the street canyon. The validation of the parameterization is made with measurements from the tower in the street canyon and directly above roof height. The results show that the urban parameterization scheme is able to catch most of the typical processes that are induced by an urban surface near the ground. The fit to measured profiles is improved in comparison with a model using the traditional approach for urban parameterization (variation of z0 to take into account the presence of a city).
A metrological field intercomparison of thermometer radiation shields in the Arctic was conducted with the aim of obtaining information to increase the worldwide comparability of air temperature measurements. Air temperature measurements are performed by different combinations of thermometers and shields. The response of each system (thermometer + shield) to local meteorological conditions depends on the system itself, limiting the comparability of air temperature measurements. Ten different models of radiation shields were included in the intercomparison, involving two campaigns: (1) the laboratory campaign, where all the instrumentation was calibrated just before and just after the field campaign, and (2) the field campaign that lasted 14 months where 41 thermometers were sampled every 2 min. All the delivered data were subjected to quality control to assure the robustness of the conclusions. A reference shield was defined, and the other shields were compared to the reference one for the conditions where maximum divergences were expected, solar irradiance being the highest impact factor. A maximum divergence value of 1.29 °C was derived for one of the shields and, for all the shields, the difference from the reference one decreases with wind speed. Finally, the uncertainties associated with the shields intercomparison were calculated.