Detection of hidden faults and sedimentary layers in the urban subsoil is significant for the utilization of the underground space, earthquake hazard mitigation, and so forth. Guilin, located in southwest China, is well known for the development of the most typical karst landform in the world and has become an international tourist city that needs scientific planning and knowledge of the urban underground space. After collecting waveform data recorded continuously over a period of about 1.5 months by a dense array of 114 short‐period seismic stations installed in and around Guilin, we adopt ambient seismic noise cross‐correlation method to extract Rayleigh‐wave phase velocity dispersion curves within the period range from 0.5 to 5 s and to obtain a high‐resolution S‐wave velocity ( ) model of the shallow crust above 9 km using surface‐wave tomography. The vertical gradient image indicates that the sediment thickness of the Guilin Karst basin is about 1–3 km. Sedimentary layers are relatively thick between Yanshan Mountain and Haiyang Mountain, and along the Yi river valley, where karst groundwater may be abundant and used as an important option for urban water supply. Both the absolute velocity image and the relative anomaly image clearly reveal the occurrence, location, and deep extension characteristics of major faults. Longsheng–Yongfu, Nanning–Guilin, Yaoshan–Yanshan, Baishi, and Guanyang–Hengyang may be regional deep faults cutting through the upper crust at least. The evolution of the basin is mainly controlled by the steep dipping Longsheng–Yongfu and Baishi faults, and partially controlled by the gently dipping Nanning–Guilin fault in the interior of the basin. The Nanning–Guilin fault is an active and partially buried fault obliquely crossing Guilin city. Urban seismic imaging, such as the new tomography presented here, can play an important role in understanding tectonic and tectonic‐subsidence earthquake hazards associated with these buried faults.
Safety assessment must accurately grasp deformation information of a high-speed railway bridge. When the ground-based radar collected high-frequency data, white and colored noises will be present in the radar signal due to the influence of environment and instrument errors. The existence of the above-mentioned two kinds of noises will affect the accurate estimation of deformation information. Based on the above situation, a ground-based real aperture radar (GB-RAR) deformation information estimation method considering the effect of colored noise was proposed in this work. The proposed method was applied to the safety monitoring and analysis of East Lake High-tech Bridge during the Wuhan Metro Line 11 shield tunnel crossing underneath this bridge. First, the settlement deformation time series of the bridge was derived based on GB-RAR, and it was verified by leveling at an accuracy better than 0.27 mm. Second, white, and colored noises were detected in the denoised settlement deformation time series through a power spectral analysis and maximum likelihood estimation, and the colored noise spectral indexes were approximately −1. Finally, according to the proposed method, the estimated settlement rates of No. 7 and 8 piers were 0.0112 ± 0.0026 and −0.0046 ± 0.0053 mm/h, and the accumulative settlement values were −0.40 and −0.16 mm, respectively. The results were in good agreement with the results of leveling measurement and more accurate than those of the deformation information estimation method without considering the effect of colored noise. The research results showed the reliability and effectiveness of the method in this work, and the bridge was stable and safe during the monitoring period.
Based on the two-dimensional (2D) three-component first-order velocity-stress equation, the high order staggered mesh finite difference numerical simulation method was used to simulate the elastic and viscoelastic tilted transversely isotropic (TTI) media. The perfect matched layer (PML) absorption boundary condition was selected to eliminate the boundary effect. The results show that: ① Under the condition of fixed elastic parameters of elastic TTI medium, when the polarization angle and azimuth are 60° and 45° respectively, the degree of shear wave splitting is significantly greater than the angle of 0°; ② The influence of viscoelasticity on TTI medium is mainly reflected in the amplitude. If the quality factor decreases, the attenuation of the seismic wave amplitude increases, causing the waveform to become wider and distorted. If the quality factor increases, the viscoelastic medium becomes closer to elastic medium; ③ For TTI medium with different polarization angle and azimuth angle in the upper and lower layers, the shear wave can multiple splits at the interface of medium. The symmetry of seismograms is affected by the polarization angle and azimuth angle of TTI medium; ④ Viscoelasticity has a great influence on reflected wave, transmitted wave and converted wave in the low-velocity model. When the viscoelasticity is strong, the weaker waves may not be shown.
Conventional well logging can effectively detect the vertical distribution range of ore bodies near the well by placing detectors in the well. However, its detection capability for the horizontal extension of ore bodies is limited. Therefore, starting from the differential equations satisfied by the point source in three-dimensional structures, this paper deduces the variational problem satisfied by the total potential under three-dimensional complex conditions. By focusing on well logging, tetrahedral cross-grid partitioning technology is employed to achieve high-precision three-dimensional finite element forward modeling. Simulations are carried out for different forms of ore bodies using the induced polarization five-direction observation method, considering the presence of ore bodies near the well and the case where the measurement well passes through the ore body. The paper analyzes and summarizes the induced polarization anomaly patterns formed by ore bodies with low resistance and high polarization in different horizontal extension directions under induced polarization five-direction logging with power supply measurements from different directions. Based on this, a human–computer interaction system is constructed to perform forward fitting and inversion interpretation of the measured induced polarization data, resulting in a good application effect.