Due to the recent miniaturization of wireless devices, the use of wearable antennas is steadily increasing. A wearable antenna is intended to be a part of the clothing used for communication purposes. In this way, a lower visual cost may be achieved. Recently, biologically inspired design, a kind of design by cross-domain analogy is a promising paradigm for innovation as well as low visual cost. The shapes of the plants are structures optimized by nature with the primary goal of light energy capture, transforming it into chemical energy. In this case, they have similar behavior to that of parabolic reflectors; this enables microwave engineers design innovative antennas using bio-inspired concepts. One of the advantages of using bio-inspired plant shapes is the design of antennas with great perimeters in compact structures. Thus, we have small antennas operating in low frequencies. This chapter presents the recent development in bio-inspired wearable antennas, easily integrated to the clothes and accessories used by the body, built in denim, low-cost flexible dielectric, and polyamide flexible dielectric, that is flexible with high resistance to twists and temperatures, for wireless body area network (WBAN) applications, operating in cellular mobile (2G, 3G, and 4G) and wireless local area network (2.4 and 5 GHz) protocols.
The design of a bio-inspired butterfly-shaped patch antenna array, generated by polar transformations, covering the wireless local area network (WLAN) band at 2.4 GHz (2.400-2.483 GHz), with similar and dissimilar elements is presented in this paper. The dissimilar bio-inspired antenna presented a bandwidth of 96MHz covering the IEEE802.11b, g band, maximum gain of 8.64dBi, concentrated half power beamwidth of 52 degrees and front-to-back ratio of 15.21dB.
An efficient iterative technique based on the wave concept (WCIP) for designing multilayer planar circuits is presented. The algorithm is based on the use of a recursive relationship between incident waves and reflected waves from several planes of discontinuity, instead of an integral equation. The convergence is insured independently of the kind or number of interfaces of the structure. The method herein presented solves for the current density and the tangential electrical field on the interface. The formulation permits to solve several problems by applying dual quantities. A two-dimensional fast modal transformation (FMT) algorithm using periodic walls is used with a 2D-FFT algorithm, in order to simplify calculations and accelerate the convergence. In this sense, a program in MATLAB has been elaborated to validate this approach. The numerical results are compared with those in the available literature.
1 January 2025 in Journal of Microwaves, Optoelectronics and Electromagnetic Applications
In this study, we developed a Radio Frequency Identification (RFID) sensor to monitor respiratory rates. The sensor utilizes a passive RFID tag enhanced with a metamaterial-inspired structure to boost its maximum gain value. This gain increased from -0.39 dBi to 0.57 dBi. Monitoring of the respiratory rate was conducted by analyzing variations in the Received Signal Strength Indicator (RSSI), which were influenced by respiratory movements. The RSSI data collected from the RFID tag readings were processed using the Daubechies wavelet of order 5 (db5) with three levels of signal decomposition, resulting in signals with reduced noise. These measurements were particularly effective when the participant was at rest, with the RFID tag positioned over the abdomen. The maximum reading range obtained was 1.04 m. The respiratory rates derived from the RSSI variations were validated against a vital signals monitor, confirming that they fell within the expected frequency variation range of the multiparameter monitor.