Behzad Nematollahi

Dr. Behzad Nematollahi

Faculty of Science, Engineering & Technology, Swinburne University of Technology, Australia
orcid

Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 May 2018 in Construction and Building Materials
Verified
Journal Article
Closed access
JSJay Sanjayan
Jay Sanjayan
BNBehzad Nematollahi
Behzad Nematollahi
MXMing Xia
Ming Xia
TMTaylor Marchment
Taylor Marchment

1 May 2015 in Ceramics International
Verified
Journal Article
Closed access
BNBehzad Nematollahi
Behzad Nematollahi
JSJay Sanjayan
Jay Sanjayan
Faiz ShaikhFaiz Shaikh
Faiz Shaikh


1 October 2020 in Construction and Building Materials
Verified
Journal Article
Closed access
AAArun R. Arunothayan
Arun R. Arunothayan
BNBehzad Nematollahi
Behzad Nematollahi
RRRavi Ranade
Ravi Ranade
SBShin Hau Bong
Shin Hau Bong
JSJay Sanjayan
Jay Sanjayan

22 November 2018 in Materials
Verified
Journal Article
Open access
PDF file
BNBehzad Nematollahi
Behzad Nematollahi
PVPraful Vijay
Praful Vijay
JSJay Sanjayan
Jay Sanjayan
ANAli Nazari
Ali Nazari
MXMing Xia
Ming Xia
VMViktor Mechtcherine
Viktor Mechtcherine
This paper investigates the effect of polypropylene (PP) fibres on the fresh and hardened properties of 3D-printed fibre-reinforced geopolymer mortars. Different percentages of PP fibres ranging between 0.25% and 1.00% by volume were added to an optimised geopolymer mixture. All samples showed reasonable workability and extrudability. In addition, shape-retention ability in the fresh state was investigated as a major requirement for 3D-printing. The compressive strength of the printed specimens was tested in the hardened state in three loading directions, viz. longitudinal, perpendicular, and lateral. The flexural strength of samples was also tested in the longitudinal and lateral directions. In addition, the interlayer bond strength was investigated. Fibre addition seems to influence compressive strengths positively only when the loading is perpendicular to the interface plane. This is due to the preferential fibre alignment parallel to the direction of extrusion. The addition of fibre significantly enhanced the flexural performance of the printed samples. The use of fibre dosages of 0.75 and 1.00 vol % caused deflection-hardening behaviour of the 3D-printed geopolymers and, hence, a significantly higher fracture energy in comparison to specimens without fibre or with lower fibre content. However, an increase in the fibre volume caused some minor reduction in interlayer bond strength. With respect to properties in the fresh state, higher fibre volumes caused better shape-retention ability in the printed samples. The results indicate the possibility of printing fibre-reinforced geopolymers which meet all the necessary properties in both the fresh and hardened states.

1 November 2019 in Materials & Design
Verified
Journal Article
Open access
BZBinrong Zhu
Binrong Zhu
JPJinlong Pan
Jinlong Pan
BNBehzad Nematollahi
Behzad Nematollahi
ZZZhenxin Zhou
Zhenxin Zhou
YZYang Zhang
Yang Zhang
JSJay Sanjayan
Jay Sanjayan