Selective water oxidation to hydrogen peroxide has emerged as an economically attractive replacement for oxygen in electrochemical hydrogen production by water splitting. Here, boron-doped diamond (BDD) is shown to be a promising anode material for anodic H2O2 formation. Faradaic efficiencies of up to 31.7% at 2.90 V versus the reference hydrogen electrode and a current density of 39.8 mA cm–2 were observed, corresponding to a H2O2 production rate of 3.93 μmol min–1 cm–2. A techno-economic evaluation based on the experimentally obtained values demonstrates that the corresponding levelized cost of hydrogen (LCH) is significant ($62.0 kg–1). Particularly, the current market price of BDD limits its implementation as a selective water oxidation anode for H2O2 generation. The sensitivity analysis however suggests that the LCH can be significantly improved by either decreasing the anode cost or increasing the current density. Both approaches are in fact feasible to allow for cost-effective electrochemical H2 production and even competition with H2 obtained from steam methane reforming. This study will guide ongoing research efforts toward BDD development and implementation of selective water oxidation to hydrogen peroxide.
Dye-sensitized photoelectrochemical (DSPEC) water splitting is an attractive approach to convert and store solar energy into chemical bonds. However, the solar conversion efficiency of a DSPEC cell is typically low due to a poor performance of the photocathode. Here, we demonstrate that Cu-doping improves the performance of a functionalized NiO-based photocathode significantly. Femtosecond transient absorption experiments show longer-lived photoinduced charge separation for the Cu:NiO-based photocathode relative to the undoped analogue. We present a photophysical model that distinguishes between surface and bulk charge recombination, with the first process (∼10 ps) occurring more than 1 order of magnitude faster than the latter. The longer-lived photoinduced charge separation in the Cu:NiO-based photocathode likely originates from less dominant surface recombination and an increased probability for holes to escape into the bulk and to be transported to the electrical contact of the photocathode. Cu-doping of NiO shows promise to suppress detrimental surface charge recombination and to realize more efficient photocathodes.
12 February 2018 in European Journal of Inorganic Chemistry
The temperature‐dependent composition of suspension during citric acid mediated crystallization of tungsten trioxide (WO3) from sodium tungstate was studied by in situ Raman spectroscopy. Additionally, microwave‐assisted hydrothermal synthesis experiments combined with ex situ analysis by X‐ray diffraction and SEM were performed to analyze the effect of pH on the eventually, isothermally, obtained crystal phase and morphology. The Raman results suggest that WO3·2H2O precipitates from the tungstate solution upon acidification to pH 0.5 at room temperature. This is first transformed to WO3·H2O initiating at T = 70 °C. At temperatures above 170 °C, the crystallization of phase‐pure monoclinic WO3 with well‐defined plate‐like morphology was observed at pH 0.5. Using the microwave‐assisted hydrothermal synthesis procedure shows that increasing the pH to values of 1.5 or 2 results in significant or dominant formation of hexagonal WO3, respectively. Comparing the activity of selected samples in photocatalytic oxidation of propane using visible light, demonstrates the presence of hydrate phases or hexagonal WO3 is detrimental to performance.
15 July 2023 in The Journal of Physical Chemistry C
Despite the promising performance of Ru nanoparticles or nanoclusters on nanostructured TiO2 in photocatalytic and photothermal reactions, a mechanistic understanding of the photophysics is limited. The aim of this study is to uncover the nature of light-induced processes in Ru/TiO2 and the role of UV versus visible excitation by time-resolved photoluminescence (PL) spectroscopy. The PL at a 267 nm excitation is predominantly due to TiO2, with a minor contribution of the Ru nanoclusters. Relative to TiO2, the PL of Ru/TiO2 following a 267 nm excitation is significantly blue-shifted, and the bathochromic shift with time is smaller. We show by global analysis of the spectrotemporal PL behavior that for both TiO2 and Ru/TiO2 the bathochromic shift with time is likely caused by the diffusion of electrons from the TiO2 bulk toward the surface. During this directional motion, electrons may recombine (non)radiatively with relatively immobile hole polarons, causing the PL spectrum to red-shift with time following excitation. The blue-shifted PL spectra and smaller bathochromic shift with time for Ru/TiO2 relative to TiO2 indicate surface PL quenching, likely due to charge transfer from the TiO2 surface into the Ru nanoclusters. When deposited on SiO2 and excited at 532 nm, Ru shows a strong emission. The PL of Ru when deposited on TiO2 is completely quenched, demonstrating interfacial charge separation following photoexcitation of the Ru nanoclusters with a close to unity quantum yield. The nature of the charge-transfer phenomena is discussed, and the obtained insights indicate that Ru nanoclusters should be deposited on semiconducting supports to enable highly effective photo(thermal)catalysis.
Ru/TiO2 catalysts are well known for their high activity in the hydrogenation of CO2 to CH4 (the Sabatier reaction). This activity is commonly attributed to strong metal–support interactions (SMSIs), associated with reducible oxide layers partly covering the Ru-metal particles. Moreover, isothermal rates of formation of CH4 can be significantly enhanced by the exposure of Ru/TiO2 to light of UV/visible wavelengths, even at relatively low intensities. In this study, we confirm the significant enhancement in the rate of formation of methane in the conversion of CO2, e.g., at 200 °C from ~1.2 mol gRu−1·h−1 to ~1.8 mol gRu−1·h−1 by UV/Vis illumination of a hydrogen-treated Ru/TiOx catalyst. The activation energy does not change upon illumination—the rate enhancement coincides with a temperature increase of approximately 10 °C in steady state (flow) conditions. In-situ DRIFT experiments, performed in batch mode, demonstrate that the Ru–CO absorption frequency is shifted and the intensity reduced by combined UV/Vis illumination in the temperature range of 200–350 °C, which is more significant than can be explained by temperature enhancement alone. Moreover, exposing the catalyst to either UV (predominantly exciting TiO2) or visible illumination (exclusively exciting Ru) at small intensities leads to very similar effects on Ru–CO IR intensities, formed in situ by exposure to CO2. This further confirms that the temperature increase is likely not the only explanation for the enhancement in the reaction rates. Rather, as corroborated by photophysical studies reported in the literature, we propose that illumination induces changes in the electron density of Ru partly covered by a thin layer of TiOx, lowering the CO coverage, and thus enhancing the methane formation rate upon illumination.