The effect of pad surface characteristics on the thermal, tribological and kinetic attributes of copper CMP was investigated. Three CMC D100 pads with very different surface micro-textures were generated using three very different CVD-coated diamond conditioning discs. Pad samples were collected after polishing and analyzed for their surface contact area and topography using confocal microscopy. The contact area, contact density, and asperity height increased with increasing conditioner aggressiveness. Copper removal rates and pad surface temperatures increased with increasing polishing pressure and sliding velocity for all pads albeit in a non-Prestonian manner. The pad generated by the most aggressive disc caused the highest removal rates yet it showed the lowest overall coefficient of friction (COF). The tall asperities, open pores, and adequate contact of this pad produced a greater removal rate than pad surfaces with shorter asperities and glazed pores produced by the less aggressive discs. Trends in COF, temperature and removal rate were successfully simulated using a two-step modified Langmuir-Hinshelwood model which also yielded values for the chemical and mechanical rate constants. The simulation results indicated that the process was chemically limited for all polishing conditions, and that the process became even more chemically limited as P × v increased.
7 March 2017 in ECS Journal of Solid State Science and Technology
This study investigated the effect of different pad surface micro-textures on the tribological, thermal and kinetic attributes during copper chemical mechanical planarization (CMP). Different micro-textures were generated by two different chemical vapor deposited (CVD) diamond-coated conditioner discs (i.e. Disc A and Disc B). Results showed that while pad temperature and removal rate increased with polishing pressure and sliding velocity on both discs, Disc B generated consistently lower removal rates and coefficients of friction (COF) than Disc A. To fundamentally elucidate the cause(s) of such differences, pad surface contact area and topography were analyzed using laser confocal microscopy. The comparison of the pad surface micro-texture analysis indicated that Disc A generated a surface having a smaller abruptness (λ) and much more solid contact area which resulted in a higher removal rate. In contrast, Disc B generated less contact areas and COF. A two-step modified Langmuir–Hinshelwood model was employed to simulate copper removal rates as well as chemical and mechanical rate constants. The simulated chemical to mechanical constant ratios indicated that Disc A produced a more mechanically limited process under all of the polishing conditions tested.
This study explored the effect of different cerium oxide abrasive particle sizes in chemical mechanical planarization of blanket plasma-enhanced tetraethylorthosilicate wafers. All polishing experiments were done with a polisher and tribometer capable of measuring shear force and down force in real-time. Coefficient of friction and removal rate were found to correlate well with the slurry median particle size distribution. Removal rate modeling based on particle size was explored to support the interpretation of the experimental results.
2 January 2005 in Journal of the Electrochemical Society