Foamed concrete is increasingly utilized in protection engineering because it offers a high energy absorption ratio and a relatively low construction cost. To investigate the dynamic properties of foamed concrete, a series of dynamic compression tests are carried out on high-density foamed concrete with densities of 800 kg/m3, 1000 kg/m3, and 1100 kg/m3 under a strain rate range of 59.05 s−1~302.17 s−1 by using a Φ-100 mm split Hopkinson pressure bar (SHPB) device. The effects of strain rate on the stress–strain relationship, dynamic compressive strength, and dynamic increase factor of foamed concrete are discussed in detail. The results show that the dynamic mechanical characteristics of foamed concrete with different densities exhibit a significant strain rate enhancement effect. Additionally, the energy absorption characteristics of foamed concrete are investigated, demonstrating that it can effectively prevent the transmission of incident energy and that its energy absorption efficiency declines as the strain rate increases. A high-speed camera was also employed to capture the failure process of foamed concrete. The results exhibit that fracture production and development induce the failure of foamed concrete, the failure process of foamed concrete advances as the strain rate increases, and the failure mode becomes increasingly severe.
25 March 2024 in KSCE Journal of Civil Engineering
Loess is a special kind of sediment, which has the characteristics of loose structure, pore development, and poor cementation. Its mechanical properties are easily affected by water content. In this study, uniaxial compression, Brazilian test, and a double-sided shear test were performed on samples of loess with different water contents. The influence of water content on the mechanical properties of loess has been thoroughly investigated. The results demonstrate a clear linear relationship between the reduction in mechanical characteristics of the loess samples with increasing water content, including compressive strength, deformation modulus, tensile strength, shear strength, cohesion, and internal friction angle. Three failure types will occur for loess samples in the uniaxial compression test as the water content increases: tensile failure, shear failure with bulging, and conical failure with general thickening. In the shear test, the general expression of the shear strength of loess samples is obtained with water content as the independent variable. Finally, a deterioration coefficient K is derived based on the strength parameters of loess samples and can be used to describe the sensitivity to water content. Shear strength is more susceptible to variations in water content than compressive and tensile strength.
4 December 2024 in Journal of Mechanical Science and Technology
The acoustic emission (AE) characteristic signal can reveal the mechanical properties of rock materials and the development characteristics of internal microcracks. Rocks with different mineral development characteristics produce different AE signals during fracture. This study selected variable metagabbros with varying feldspathic development for AE tests under splitting load. The results demonstrated that the characteristics of AE ringing counts during the Brazilian fracture of metagabbro were closely correlated with the content of felsic minerals. The cumulative AE ringing count of metagabbros with feldspar nondevelopment exceeded 250 000, while those of metagabbros with feldspar development did not reach 200 000. As the feldspathic mineral content increases, the AE ringing counts of metagabbro exhibit an increasing trend in the high-energy (1e6–+∞ aJ) and high-amplitude (90–100 dB) intervals. With the development of feldspar minerals, the fracture mode of metagabbro gradually changed from shear failure to tensile failure. The higher the development of felsic minerals, the higher the stress level corresponding to the maximum fractal dimension, the greater the energy released by rock failure, and the more severe the damage. This study is of great significance for revealing the mechanism of rock rupture.