Soil bioengineering provides a sustainable method for erosion control and soil slope stabilization using vegetation with multiple co-benefits. This study evaluated ten plant species in Thailand’s highland regions for their soil bioengineering potential and additional benefits. Root architecture, tensile strength, and Young’s modulus were measured to compare biomechanical traits. G. sepium, F. griffithii, P. americana, B. asiatica, and C. arabica exhibited H-type roots with wide lateral spread, while M. denticulata and C. officinarum had VH-type roots with deep taproots and wide lateral extent. A. sutepensis showed M-type roots with most root matrix in the top 0.3 m, where C. cajan and C. sinensis had R-type roots with deep, oblique growth. Most species showed a negative power relationship between the root strength and Young’s modulus with the root diameter except C. cajan that showed a positive correlation. P. americana, F. griffithii, C. officinarum, and C. arabica showed relatively high values of 1 mm root tensile strength (exceeding 24 to 42 MPa), while M. denticulata, G. sepium, and B. asiatica exhibited intermediate root tensile strength (ranging from 8 to 19 MPa). A. sutepensis, C. cajan, and C. sinensis demonstrated the lowest root tensile strength, up to 7 MPa. It is advised to plan slope vegetation by selecting diverse plant species with varying root structures and benefits, addressing both engineering and socioeconomic needs of the sustainable nature-based solution.
Biomass-derived activated carbons exhibit high adsorption capacity; however, their powdered form often suffers from aggregation, poor recoverability, and secondary dispersion in aqueous systems, limiting practical application. To address these challenges while preserving adsorption efficiency, a sustainable biopolymer activated carbon composite aerogel (AC-BPA) was fabricated. The aerogel was made by homogeneous integration of KOH-activated cocoa pod husk–derived carbon into a chitosan/HPMC/MC matrix. The physical characteristics of the aerogel displayed a high BET surface area (496.2 ± 32 m² g⁻¹), large pore volume (2.78 ± 0.7 cm³ g⁻¹), high porosity (96.1%), and ultralow density (0.0396 ± 0.002 g cm⁻³), facilitating rapid mass transfer and abundant accessible adsorption sites. The efficacy of AC-BPA was assessed in batch experiments for the removal of Zn²⁺ and Cu²⁺ ions from aqueous solution. Results demonstrated that adsorption efficiency increased with contact time, and with optimum metal uptake occurring at near-neutral pH (6-7). Kinetic analysis indicated that Zn²⁺ and Cu²⁺ adsorption followed the pseudo-first-order model (R² = 0.99 and 0.95, respectively). Isotherm studies revealed that Zn²⁺ adsorption was better described by the Freundlich model (R² = 0.98), whereas Cu²⁺ followed the Langmuir model (R² = 0.99), with adsorption capacities of 69.8 mg g⁻¹ and 68.49 mg g⁻¹, respectively. The enhanced performance is attributed to synergistic interactions between the porous carbon framework and biopolymer functional groups (–NH₂ and –OH), involving electrostatic attraction, surface complexation, ion exchange, and pore diffusion. These findings demonstrate the potential of biomass-derived composite aerogels as efficient and sustainable adsorbents for wastewater remediation.