Coated diammonium phosphate (CDAP) is intended to release nutrients steadily in response to the demand of crop growth. A novel biostimulant extracted from Paecilomyces variotii has been shown to regulate gene expression in nutrient transport, enhance nitrogen (N) and phosphorus (P) uptake, and improve nutrient use efficiency. The application of CDAP combined with the Paecilomyces variotii extracts (ZNC) in maize is an efficient approach for reducing waste of resources, improving nutrient supply, and maintaining production stability. The effects of CDAP combined with ZNC on photosynthesis, enzyme activities, endogenous hormone content, maize yield, and P use efficiency (PUE) were investigated in this study. In a pot experiment, CDAP and diammonium phosphate (DAP) were tested together with P levels (1.80, 1.44 g pot–1, P2O5) and two ZNC application rates (0, 4.4 μg pot–1), which included the control treatment that had no P fertilizer added. Results showed that the key influencing elements of maize growth and yield were the soil available-P content, endogenous hormone content, and plant photosynthesis in this study. The combination of DAP and ZNC increased the soil available-P content and the auxin content in leaves at the key stage and hence increased the yield and PUE of maize, compared with DAP. The net photosynthetic rate of CDAP combined with ZNC was higher by 23.1% than that of CDAP alone, as well as by 32.0% than that of DAP combined with ZNC. Moreover, the combination of CDAP and ZNC increased the yield and PUE by 8.2% and 15.6 percentage points compared with DAP combined with ZNC while increasing the yield and PUE compared with CDAP. In conclusion, combining CDAP with ZNC as an environmentally friendly fertilizer could improve photosynthesis-related enzyme activity and enhance the net photosynthetic rate, resulting in an increase in maize yield and PUE significantly.
Extraction optimization is very important for the quality of humic acid (HA). In this study, actived HA (HAb) was extracted from danty via catalytic oxidation using birnessite as a catalyst and H2O2 as an oxidant. Single-factor experiments and the response surface method were used to optimize the acidic functional group content of HAb. It was found that the maximum acidic functional group content of HAb can be achieved when danty-crushing time, H2O2 concentration, and birnessite dose were 105.7 min, 20, and 2%, respectively. Fourier transform infrared spectra showed that HAb had more surface functional groups than commercial HA (HAc) and HA extracted using the traditional method of the International Humic Substances Society (HAI). In addition, acidic functional group titration showed that HAb had 84.3% more acidic functional groups and 118.9% more carboxyl groups than HAI. Additionally, HAb had the greatest effect on promoting the dissolution of carbonate and bicarbonate, promoting the settlement of calcaline alkaline soil, and improving the germination rate of wheat seeds under saline and alkaline stress. This study provides a basis for the efficient extraction of active HA with rich functional groups and its application in agriculture and many other fields.
6 September 2025 in Journal of Environmental Management
The development of controlled-release fertilizers (CRFs) has faced significant challenges due to high hydrophilicity and short release lifespan of bio-based materials, as well as non-renewable and high cost of polyester polyols (PPs). In this study, lignin-based polyols (LPs) and PPs were modified to form a cross-linked polymer film on the surface of urea through an in situ reaction. This approach effectively balanced the slow-release ability and environmental protection of controlled-release fertilizer films. A two-factor, five-level orthogonal test was designed for the mass ratio of lignin/polyester polyol and polyol/polyaryl polymethylene isocyanate (PAPI), comprising a total of 25 treatments. The results indicated that the appropriateness of lignin polyols increased the hydrogen bond content of polyurethane membrane, improved the mechanical strength of the fertilizer membrane shell, and effectively reduced friction losses during storage and transportation. Moreover, optimizing the polyol-to-PAPI ratio minimized coating porosity, produced a smoother and denser surface, and prolonged the nitrogen release period. When the lignin polyol dosage was 25% and the polyol to PAPI ratio was 1:2, the nitrogen release time of the prepared coated urea extended to 32 days, which was 3.5 times longer than that of lignin polyurethane coated urea (7 days). The incorporation of lignin and the optimal ratio of coating materials significantly improved the controlled-release efficiency of coated fertilizer, providing theoretical support for the sustainable agricultural application of biomass.
2 December 2025 in Journal of Soil Science and Plant Nutrition