Accurate and rapid prediction of pesticides in groundwater is important to protect human health. Thus, an electronic nose was used to recognize pesticides in groundwater. However, the e-nose response signals for pesticides are different in groundwater samples from various regions, so a prediction model built on one region’s samples might be ineffective when tested in another. Moreover, the establishment of a new prediction model requires a large number of sample data, which will cost too much resources and time. To resolve this issue, this study introduced the TrAdaBoost transfer learning method to recognize the pesticide in groundwater using the e-nose. The main work was divided into two steps: (1) qualitatively checking the pesticide type and (2) semi-quantitatively predicting the pesticide concentration. The support vector machine integrated with the TrAdaBoost was adopted to complete these two steps, and the recognition rate can be 19.3% and 22.2% higher than that of methods without transfer learning. These results demonstrated the potential of the TrAdaBoost based on support vector machine approaches in recognizing the pesticide in groundwater when there were few samples in the target domain.
Friction pairs in heavy-duty power-shift tractor wet clutches operate under complex conditions, making them vulnerable to damage and reducing reliability. Optimizing their tribological performance requires a trade-off between a high coefficient of friction (COF) for torque transmission and a low temperature rise () to prevent thermal damage. Surface texturing is an effective method for improving the tribological performance of friction pairs. This study simulated the friction of wet clutch pairs via pin-on-disk tests and designed micro-textures on the pin surface to enhance tribological performance. Based on the experimental data, a Gaussian Process Regression (GPR) surrogate model was developed to accurately predict COF and as a function of the clutch’s operating and micro-texture’s geometric parameters. A Multi-Objective Particle Swarm Optimization (MOPSO) algorithm was then employed to obtain the optimal set of solutions. The obtained pareto front clearly revealed the COF–temperature rise trade-off. From the optimal solution set, optimal micro-texture parameters for two typical operating conditions of different clutches were extracted. Compared with the untextured surface, the optimal solutions increased COF by 2.6%/1.2% and reduced by 39.2%/12.1%. Relative to neighboring experimental points, COF further increased by 11.3%/2.7% and decreased by 16.6%/1.7%. This work establishes a method for balancing the frictional and thermal performance of friction pairs.