Al-doped ZnO (AZO) films of thickness with various Al doping were prepared at by atomic layer deposition on quartz substrates. At low Al doping, the films were strongly textured along the [100] direction, while at higher Al doping the films remained amorphous. Atomic force microscopy results showed that Al–O cycles when inserted in a ZnO film, corresponding to a few atomic percent Al, could remarkably reduce the surface roughness of the films. Hall measurements revealed a maximum mobility of . Film resistivity reached a minima of whereas the carrier concentration reached a maxima of , at 3 at. % Al. The band gap of AZO films varied from 3.23 eV for undoped ZnO films to 3.73 eV for AZO films with 24.6 at. % Al. Optical transmittance over 80% was obtained in the visible region. The detrimental impact of increased Al resulting in decreased conductivity due to doping past 3.0 at. % is evident in the x-ray diffraction data, as an abrupt increase in the optical band gap and as a deviation from the Burstein–Moss effect.
1 March 2015 in Journal of Nanoscience and Nanotechnology
Ultra-thin ZrOx thin films on Si substrates were prepared by sol–gel technique and processed with different methods (baked on hot plate at 150 °C, annealed at 500 °C in furnace, and photoannealed under UV light). The decomposition of the organic groups and the formation of Zr —O bonding in the ZrOx thin films were confirmed by Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy. It is found that the ZrOx thin film annealed under UV light shows decent characteristics, including an ultra-small surface roughness, a low leakage current density of 10−9 A/cm2 at 1 MV/cm, a large breakdown electric field of 9.5 MV/cm, and a large areal capacitance of 775 nF/cm2.
InTiZnO thin-film transistors (ITZO TFTs) with Al2O3 gate dielectrics are fabricated by magnetron sputtering at room temperature. The bottom-gate-type ITZO TFTs with amorphous Al2O3 gate dielectrics are operated in the enhancement mode and exhibit a mobility of 50.4 cm2/V·s, threshold voltage of 1.2 V, subthreshold swing of 94.5 mV/decade, and on/off-current ratio of 7 × 106. We believe that ITZO deposited at room temperature is an appropriate semiconductor material to produce high-mobility TFTs for developing flexible electronic devices.