We show that upon applying Palatini , characterized by an term, within a scenario motivated by a temporal variation of strong coupling constant, then one obtains a quadratic kinetic energy. We do not drop this term, but rather study two extreme cases: and . In both cases, one can generate a kinematically-induced inflationary paradigm. In order to fit the Planck 2018 data, the case, called k-inflation, requires a fine tuning adjustment with nonvanishing nonminimal coupling to gravity parameter , whereas the case, studied in the constant-roll regime, can fit the data for vanishing . The varying strong coupling inflation scenario remains viable when implemented through a warm inflation scenario with or without gravity.
We investigate natural inflation with non-minimal coupling to gravity, characterized either by a quadratic or a periodic term, within the warm inflation paradigm during the slow-roll stage, in both strong and weak dissipation limits; and show that, in the case of a T-linearly dependent dissipative term, it can accommodate the spectral index and tensor-to-scalar ratio r observables given by Planck 2018 constraints, albeit with a too-small value of the e-folding number to solve the horizon problem, providing, thus, only a partial solution to natural inflation issues, assuming a T-cubically dependent dissipative term can provide a solution to this e-folding number issue.
The optical properties of 1 μm polystyrene in the wavelength range of 500–750 nm were estimated by using a white light spectrophotometric transmittance spectroscopy and a single integrating sphere system. To retrieve the optical characteristics, two analytical methods, namely, diffusion approximation and Kubelka–Munk were used, and then their results were compared with Mie theory calculations. The correspondence of the Kubelka–Munk scattering coefficient with Mie was obvious, and relative errors varied between 6.73% and 2.66% whereas errors varied between 6.87% and 3.62% for diffusion theory. Both analytical methods demonstrated the absorption property of polystyrene over the abovementioned wavelength range. Although absorption coefficient turned out to be much lower than scattering, constructing a realistic optical phantom requires taking into account absorption property of polystyrene. Complex refractive index of polystyrene based on these two methods was determined. Inverse Mie algorithm with scattering coefficient was also used to retrieve the real part of refractive index and absorption coefficient for calculating the imaginary part of refractive index. The relative errors of the real part did not exceed 2.6%, and the imaginary part was in consistence with the prior works. Finally, the presented results confirm the validity of diffusion theory with a single integrating sphere system.
Power-law inflation with scale factor $$a \propto t^m$$ is investigated in the context of warm inflation. The treatment is performed in the weak and strong dissipation limits. In addition, we discuss the three common cases for the thermal dissipation coefficient $$\varGamma (T)$$ . We compare the theoretical results of the power-law model within warm inflation with the observational constraints from Planck 2018 and BICEP/Keck 2018, as presented by the tensor-to-scalar ratio r and spectral index $$n_s$$ . The model results agree largely with the observations for most of the $$\varGamma (T)$$ cases. Furthermore, in order to address the problem of exiting the inflationary epoch, we suggest a perturbed modification to the power-law definition so that it becomes affine, and find that this small change indicates a way for having an exit scenario with a suitable e-foldings number. Finally, we examine this perturbation ansatz within the context of cold inflation with exponential potential, and we find that it can accommodate the observational data with sufficient e-foldings. Our study suggests that the power-law inflation and the exponential potential, in both warm and cold inflation contexts, can in principle be made consistent with the observations and with a possible graceful exit.
This paper introduces a new modification for the well-known binary detour phase method, which is largely used to represent Fourier holograms; the modification utilizes gray scale level control provided by a liquid crystal spatial light modulator to improve the traditional binary detour phase. Results are shown by both simulation and experiment.