Membrane distillation (MD) is constantly acknowledged in the research literature as a promising technology for the future of desalination, with an increasing number of studies reported year after year. However, real MD applications still lag behind with only a few pilot-plant tests worldwide. The lack of technology transfer from academia to industry is caused by important gaps between its fundamental basis and the process design. Herein, we explore critical disconnections by conducting coupled mass and heat transfer modeling and MD simulations; we use well-known MD mass and heat transfer equations to model and simulate flux over a typical MD membrane for different geometries, areas, and operational conditions in direct contact configuration. From the analysis of the results, we propose research guidelines and process development strategies, and construct an MD module performance curve. From this graph, permeate flow rate, thermal energy consumption and outlet temperatures can be determined for given feed inlet conditions (temperature and concentration). Comprehensive tools such as this MD module curve and good communication between membrane developers and process engineers are required to accelerate the process of bringing the MD technology from a still-emerging status to a maturity level.
20 February 2024 in ACS Sustainable Chemistry & Engineering
5-Hydroxymethylfurfural (HMF) and furfural (Fur) are promising biobased platform chemicals, derived from the dehydration of carbohydrate feedstocks, normally conducted in an aqueous phase. Plagued by side-reactions in such phase, such as the rehydration to levulinic acid (LA) and formic acid (FA) or self-condensation to humins, HMF and Fur necessitates diversification from monophasic aqueous reaction systems toward biphasic systems to mitigate undesired side-reactions. Here, a methodology based on the COnductor-like Screening MOdel for Real Solvents (COSMO-RS) method was used to screen solvent candidates based on the predicted partition coefficients (Ki). Hansen solubility parameters in conjunction with excess thermodynamic quantities determined by COSMO-RS were employed to assess solvent compatibility. Experimental validation of the COSMO-RS values highlighted only minor deviations from the predictions with root-mean-square-error (RMSE) values of HMF and Fur at 0.76 and 5.32, respectively, at 298 K. The combined effort suggested cyclohexanone, isophorone, and methyl isobutyl ketone (MIBK) as the best candidates. Finally, extraction solvent reuse demonstrated cyclohexanone suitability for HMF extraction with KHMF of 3.66 and MIBK for Fur with KFur 7.80 with consistent partitioning across four total runs. Both solvents are classified as recommended by the CHEM21 solvent selection guide, hence adding to the sustainability of the process.