Observing the intricate microstructure changes in abrasive flow machining with traditional experimental methods is difficult. Molecular dynamics simulations are used to look at the process of abrasive flow processing from a microscopic scale in this work. A molecular dynamics model for micro-cutting a single crystal γ-TiAl alloy with a rough surface in a fluid medium environment is constructed, which is more realistic. The evolution of material removal, cutting force, temperature, energy, and dislocation during micro-cutting are analyzed. The impact of cutting depth, abrasive particle sizes, and abrasive material on the micro-cutting process are analyzed. The analysis shows that the smaller cutting depth and abrasive particle sizes are beneficial to obtain a better machining surface, and the cubic boron nitride (CBN) abrasive is an effective substitute material for diamonds. The purpose of this study is to provide unique insights for improving the material removal rate and subsurface quality by adjusting machining parameters in actual abrasive flow precision machining.
This study employed nano-indentation technology, molecular dynamics simulation, and experimental investigation to examine the stress relaxation behaviour of a polycrystalline γ-TiAl alloy. The simulation enabled the generation of a load-time curve, the visualisation of internal defect evolution, and the mapping of stress distribution across each grain during the stress relaxation stage. The findings indicate that the load remains stable following an initial decline, thereby elucidating the underlying mechanism of load change during stress relaxation. Furthermore, a nano-indentation test was conducted on the alloy, providing insight into the load variation and stress relaxation behaviour under different loading conditions. By comparing the simulation and experimental results, this study aims to guide the theoretical research and practical application of γ-TiAl alloys.
The surface quality of high-performance impellers, which feature complex, free-form surfaces and narrow flow channels, is critically important for their performance and efficiency. However, achieving uniform precision polishing on these intricate geometries remains a significant manufacturing challenge, as traditional methods are often inefficient, inaccessible, or cause surface damage. To address this, this study investigates the application of solid–liquid two-phase abrasive flow machining (AFM) as a high-precision finishing solution. Through numerical simulation, we analyzed the polishing effects under two flow channel structures and various machining parameters. The results demonstrate that a gradual flow channel structure significantly enhances processing uniformity and intensity compared to a direct flow channel. Furthermore, increasing the inlet pressure and abrasive viscosity was found to substantially improve both the strength and uniformity of the machining effect across the impeller surface. Experimental validation via an orthogonal test design confirmed that inlet pressure is the most influential factor on the polishing effect, followed by abrasive grain size and the number of processes. The optimized process parameters (6 MPa inlet pressure, 10 process cycles, and 40 µm abrasive grain size) successfully reduced the average surface roughness (Ra) of the high-performance impeller from 0.766 µm to 0.047 µm, representing an improvement of nearly 94%. This study provides a scientifically grounded set of optimal parameters for achieving uniform, high-quality surface finishing of complex impellers using AFM technology.