Short-wavelength infrared photodetectors based on metamorphic InGaAs grown on GaSb substrates and InP substrates are demonstrated. The devices have a pBn structure that employs an AlGaAsSb thin layer as the electron barrier to suppress dark current density. The strain effect on the electrical performance of the devices was specifically studied through the growth of the pBn structure on different substrates, e.g., InP and GaSb, via a specific buffering technique to optimize material properties and minimize dark current. A lower device dark current density, down to 1 × 10−2 A/cm2 at room temperature (295 K), was achieved for the devices grown on the GaSb substrate compared to that of the devices on the InP substrate (8.6 × 10−2 A/cm2). The improved properties of the high-In component InGaAs layer and the AlGaAsSb electron barrier give rise to the low dark current of the photodetector device.
Infrared (IR) photodetectors are indispensable to modern optoelectronic systems, ranging from night vision imaging, surveillance, and industrial process control to environmental monitoring and medical diagnostics. However, traditional detectors based on bulk semiconductors are constrained by prohibitive fabrication costs and the stringent requirement for bulky cryogenic cooling, which severely hinders their widespread deployment in Size, Weight, and Power (SWaP)-sensitive scenarios. Silicon-based on-chip integration, leveraging compatibility with mature CMOS processes, has emerged as a transformative paradigm. It enables the realization of fully functional photonic integrated circuits (PICs) capable of on-chip sensing and high-speed data transmission, offering a pathway toward miniaturized and cost-effective architectures. This article provides a review of recent progress in silicon-based infrared photodetectors across three core material systems: Group IV (Ge/GeSn), III–V compounds, and two-dimensional (2D) materials. In the end, we offer an outlook on the development trends of next-generation intelligent sensing systems driven by optoelectronic convergence.
In this paper, high-uniformity silicon avalanche photodiode (APD) arrays are reported. Silicon multiple epitaxy technology was used, and the high performance APD arrays based on double-layer epiwafers are achieved for the first time, to the best of our knowledge. A high-uniformity breakdown voltage with a fluctuation of smaller than 3.5 V is obtained for the fabricated APD arrays. The dark currents are below 90 pA for all 128 pixels at unity gain voltage. The pixels in the APD arrays show a gain factor of larger than 300 and a peak responsivity of M = 1 at 850 nm (corresponding to maximum external quantum efficiency of 81%) at room temperature. Quick optical pulse response time was measured, and a corresponding cutoff frequency up to 100 MHz was obtained.
Since the avalanche phenomenon was first found in bulk materials, avalanche photodiodes (APDs) have been exclusively investigated. Among the many devices that have been developed, silicon APDs stand out because of their low cost, performance stability, and compatibility with CMOS. However, the increasing industrial needs pose challenges for the fabrication cycle time and fabrication cost. In this work, we proposed an improved fabrication process for ultra-deep mesa-structured silicon APDs for photodetection in the visible and near-infrared wavelengths with improved performance and reduced costs. The improved process reduced the complexity through significantly reduced photolithography steps, e.g., half of the steps of the existing process. Additionally, single ion implantation was performed under low energy (lower than 30 keV) to further reduce the fabrication costs. Based on the improved ultra-concise process, a deep-mesa silicon APD with a 140 V breakdown voltage was obtained. The device exhibited a low capacitance of 500 fF, the measured rise time was 2.7 ns, and the reverse bias voltage was 55 V. Moreover, a high responsivity of 103 A/W@870 nm at 120 V was achieved, as well as a low dark current of 1 nA at punch-through voltage and a maximum gain exceeding 1000.
In this letter, we report a high-uniformity 2×128 silicon avalanche photodiode linear array for 3D imaging. The 100 μm diameter, 50 μm gap pixels incorporate floated guard ring and edge implantation to prevent premature breakdown. Despite the large scale, breakdown voltage uniformity across all 256 pixels exceeds 98.8%. At room temperature, pixels show 0.55 A/W peak responsivity at gain=1 (80% external quantum efficiency at 875 nm) and maximum gain exceeds 550 at 95% breakdown voltage. The array exhibits a 1.6 V deviation in breakdown voltages from 122.8~126 V across pixels, indicating a high uniformity larger than 98.8%. Dark current remains below 60 pA at gain=1 and 300 pA at 90% breakdown voltage per pixel. The capacitance is below 0.4 pF near avalanche. Furthermore, we measured the dark current-voltage characteristic at various temperatures, and a consistently low dark current, at approximately 10 nA, was obtained at a temperature up to 100 °C. These results represent a significant advance for silicon linear arrays in 3D imaging.