This paper investigates the tensile properties of jute-reinforced composites fabricated using stereolithography (SLA) 3D printing. Tensile tests were conducted using dog-bone tensile specimens following ASTM D638 Type IV specifications. Additionally, the study explores the effect of layer thickness on the tensile properties of the 3D-printed composite material, examining four different layer thicknesses: 0.025 mm, 0.05 mm, 0.075 mm, and 0.1 mm. The findings revealed that the tensile strength of the 3D-printed jute-reinforced composites increased with the printing layer thickness, reaching its maximum at a layer thickness of 0.1 mm. This represents an enhancement of approximately 84% compared to pure resin. Examination of the fiber–matrix interface under an optical microscope revealed a wavy pattern, suggesting that the interface may act as a mechanical interlock under tensile loads, thereby significantly enhancing tensile strength. The strength of the 3D-printed jute-reinforced composites was found to be comparable to that of glass fiber mat epoxy composites. This demonstrates that 3D SLA-printed jute-reinforced composites offer a promising avenue for producing next-generation composites that are typically challenging to manufacture using traditional fabrication techniques.

The growing interest in sustainable and biodegradable materials has prompted significant attention towards natural fiber-reinforced composites (FRC) due to their lower environmental impacts. In a similar sustainable vein, this study fabricated composite materials utilizing bagasse fibers with the 3D SLA (Stereolithography) printing method. To start with, a novel fiber extraction process was adopted for extracting fiber from the bagasse stem in three distinct methods (Process-1, Process-2, and Process-3). The fiber extraction process includes washing, sun-drying, manual collection of rind fibers, immersion of rind fibers in NaOH at specific concentrations for specific durations, combing, and drying. In Process-1, the rind fibers were immersed in 5% NaOH for 15 h, while in Process-2 and Process-3, the rind fibers were immersed in 1% NaOH, but the soaking time varied: 25 h for Process-2 and 18 h for Process-3.for 25 h, and in Process-3, the rind fibers were immersed in 1% NaOH for 18 h. The resulting bagasse fibers underwent comprehensive property assessment with a focus on functional group analysis, diameter measurement, and tensile strength assessment. Subsequently, these fibers were used to fabricate composite materials via the 3D SLA printing technique after being treated in a NaOH solution. The Fourier Transform Infrared (FTIR) Spectroscopy results clearly showed that a fraction of hemicellulose and lignin was removed by NaOH, resulting in improved tensile strength of the bagasse fibers. Three-dimensional-printed composites reinforced with bagasse fibers extracted through the P1 method showed the highest improvement in tensile strength (approximately 70%) compared to specimens made from pure resin. The lack of pores in the composite and the observable fiber fracture phenomena clearly indicate that 3D printing technology effectively enhances the quality of the interface between the fiber and the matrix interfacial bonding, consequently resulting in improved tensile properties of the composites. The 3D-printed composites reinforced with bagasse fiber showcased impressive tensile properties and provided solutions to the limitations of traditional composite manufacturing methods. This sets the stage for developing innovative composite materials that combine natural fibers with cutting-edge fabrication techniques, offering a promising path to tackle present and future economic and ecological challenges.