Highly solar light-absorbing poly(vinyl alcohol) (PVA) nanocomposite films have garnered wide attention in fields such as flexible optoelectronics, solar energy harvesting, and photothermal therapy. However, fabricating PVA nanocomposite films with a broad spectrum of solar absorption using cost-effective and non-toxic nanofillers remains challenging. Herein, nanocomposite films of PVA incorporating various concentrations of mixed-phase 2D MoSe2 nanosheets (i.e., a combination of the 2H and 1T phase) were prepared using a solution casting technique. Scanning electron microscopy (SEM) shows homogenous dispersion of MoSe2 nanosheets in the PVA matrix even at higher concentrations, while atomic force microscopy (AFM) reveals increasing surface roughness with increasing MoSe2 content, reaching a plateau after 20 wt%. With the increase in the concentration of MoSe2, the nanocomposite films exhibit interesting light absorption characteristics reaching their highest absorption (average 94.9%) at 40 wt% MoSe2. The incorporated mixed-phase MoSe2 nanosheets induce a significant change in the energy levels of the PVA matrix, which is reflected in the reduced optical band gap energy (2.63 eV) at 40 wt% MoSe2 against pure PVA (5.28 eV). The excellent light absorption of PVA nanocomposite films across the entire range from 250 nm to 2500 nm is attributed to the thin 2D structure of MoSe2 and the presence of its mixed phase.
One of the most versatile techniques to study thermal transport in low dimensional materials utilizes a suspended micro-island device integrated with resistance thermometers. Advancements in experimental techniques with suspended micro-island devices resulted in increasing capabilities such as enhancing temperature resolution and expanding a measurable range of sample thermal conductance. In this work, we further improve the suspended micro-island based technique. Specifically, we present a rigid structure of the suspended micro-island device and robust measurement method for sequential heating. The rigid structure enabled by T-shaped beams prevents the displacement of suspended micro-islands, thus increasing the success rates of sample transfer especially for samples with a large cross-sectional area and short length. Besides, thermal isolation of micro-islands is maintained at a similar level through the T-shaped beams compared to conventional flat beams. Next, we introduce an advanced experimental approach that enables sequential heating to measure sample thermal conductance. Sequential heating in micro-islands can be used either to measure accurate sample thermal conductance even under unexpected asymmetric supporting beam configuration or to study thermal transport dependence on heat flow directions. Using a switch matrix for sequential heating eliminates the need for experimental reconfigurations during the experiment. We demonstrate the experimental method with thermal conductivity measurements of the Si nanowire under both the ideal symmetric beam configuration and replicated asymmetric beam configuration scenarios. The results show that the developed experimental method effectively eliminates potential experimental errors that can arise from the asymmetry in beam configurations.