Leveraging waste heat has been considered to have significant potential for promoting the economic feasibility of wastewater treatment in unconventional oil and gas (UOG) production. However, its availability near well sites has not been fully understood and other energy sources may be also feasible. In this work, we quantitatively investigate the viability of using waste heat and well-pad natural gas to power on-site wastewater treatment by membrane distillation (MD) for twenty randomly selected wells located in the Denver-Julesburg (DJ) Basin, U.S. Results show that waste heat produced from on-site electrical loads is insufficient for MD treatment of all the wastewater generated during UOG production (2.2-24.3% of thermal energy required for MD treatment). Waste heat from hydraulic fracturing, which persists only for a short timeframe, is able to meet the full or partial energy requirement during the peak period of wastewater production (17-1005% of thermal energy required for MD treatment within the first two months of production), but this scenario varies among wells and is dependent on the energy efficiency of MD. Compared to waste heat, natural gas is a more consistent energy source. The treatment capacity of MD powered by natural gas at the well pad exceeds full wastewater treatment demands for all the twenty wells, with only two wells requiring short-term wastewater storage. Our work indicates that although waste heat has the potential to reduce the electricity consumption and cost of UOG wastewater treatment, it is unlikely to supply sufficient thermal energy required by MD for long-term treatment. Natural gas can serve as an alternative or complementary energy resource. Further investigations, in particular techno-economic analyses, are needed to identify the best suitable energy source or combination for on-site UOG wastewater treatment.
4 January 2025 in Energy Conversion and Management
High-temperature silicon carbide (SiC) die are the most critical and expensive component in electric vehicle (EV) power electronics (PE) packages and require both active and passive methods to dissipate heat during transient operation. The use of phase change materials (PCMs) to control the peak junction temperature of the SiC die and to buffer the temperature fluctuations in the package during simulated operation is modeled here. The latent heat storage potential of multiple PCM and PCM composites is explored in both single-sided and dual-sided package configurations. The results of this study show that the addition of PCM into two different styles of PE packages is an effective method for controlling the transient junction temperatures experienced during two different drive cycles. The addition of PCM in a single-sided package also serves to decrease temperature fluctuations experienced and may be used to reduce the necessary number of SiC die required for EVs, lowering the overall material cost and volume of the package by over 50%. PCM in a single-sided package may be nearly as effective as the double-sided cooling approach of a dual-sided package in the reduction of both peak junction temperature of SiC as well as controlling temperature variations between package layers.
A jet impingement cooling device was designed with jet-adjacent fluid extraction ports distributed throughout the impingement array. The device was fabricated from a photopolymer material using a three-dimensional printing technique and tested for flow resistance and cooling performance using water as the working fluid. Parallel to physical experiments, computational simulations were performed using a quarter-jet repeating unit cell consistent with the physical device geometry, but independent of the manifold architecture. Pressure drop and heat transfer results from both methods were evaluated and compared. It was found that the computational and experimental pressure drop results showed excellent agreement after manifold pressure drops were properly accounted for using a reduced-order analytical model. Heat transfer results were shown to have reasonable agreement with differing trends. A discussion on possible causes for the difference is presented and suggestions are made for future accommodation. Finally, this work proposes a strategy for development of broadly applicable thermal and pressure drop correlations which span a wide range of geometries, fluid properties, heat fluxes, and flow parameters.