In this paper, we study the influence of sample geometry on the measurement of pressure‐saturation relationships, by analyzing the drainage of a two‐phase flow from a quasi‐2‐D random porous medium. The medium is transparent, which allows for the direct visualization of the invasion pattern during flow, and is initially saturated with a viscous liquid (a dyed glycerol‐water mix). As the pressure in the liquid is gradually reduced, air penetrates from an open inlet, displacing the liquid which leaves the system from an outlet on the opposite side. Pressure measurements and images of the flow are recorded and the pressure‐saturation relationship is computed. We show that this relationship depends on the system size and aspect ratio. The effects of the system's boundaries on this relationship are measured experimentally and compared with simulations produced using an invasion percolation algorithm. The pressure build up at the beginning and end of the invasion process are particularly affected by the boundaries of the system whereas at the central part of the model (when the air front progresses far from these boundaries), the invasion happens at a statistically constant capillary pressure. These observations have led us to propose a much simplified pressure‐saturation relationship, valid for systems that are large enough such that the invasion is not influenced by boundary effects. The properties of this relationship depend on the capillary pressure thresholds distribution, sample dimensions, and average pore connectivity and its applications may be of particular interest for simulations of two‐phase flow in large porous media.
We study the effects of connectivity enhancement due to film flow phenomena on the drainage of an artificial porous medium and the relative influence of gravity for such effects. The medium is initially fully saturated with a liquid (wetting phase), which is displaced by air (nonwetting phase). Our setup allows us to directly visualize the dynamics of the flow and, in particular, to pinpoint which pore invasion events are due to film flow phenomena. We have observed the formation of an active zone behind the liquid-air interface, inside which film flow drainage events are more likely to occur. Understanding the basic mechanisms of film flow in artificial porous media is of relevance for the analysis of real three-dimensional porous systems, in which gravity cannot be neglected and film flow is bound to be present.
The intermittent dynamics of slow drainage flows in a porous medium is studied experimentally. This kind of two-phase flow is characterized by a rich burst activity and our setup allows us to characterize those bursts directly via images of the flow and pressure measurements. Two different boundary conditions were analyzed: controlled withdrawal rate (CWR) and controlled imposed pressure (CIP). We have characterized geometrical and statistical properties of the bursts from images and pressure measurements. We have shown that in spite of leading to similar final invasion patterns, some dynamical features of the invasion differ considerably between the CWR and CIP boundary conditions. In particular, their pressure signatures are very distinct, which then translates into very distinct features on the power spectrum density of the pressure signals. A fully integrable analytical framework is presented which successfully describes the scaling features of the power spectrum for the CIP case.
The intermittent burst dynamics during the slow drainage of a porous medium is studied experimentally. We have shown that this system satisfies a set of conditions known to be true for critical systems, such as intermittent activity with bursts extending over several time and length scales, self-similar macroscopic fractal structure and power spectrum. Additionally, we have verified a theoretically predicted scaling for the burst size distribution, previously assessed via numerical simulations. The observation of power spectra is new for porous media flows and, for specific boundary conditions, we notice the occurrence of a transition from 1/f to 1/f2 scaling. An analytically integrable mathematical framework was employed to explain this behavior.
Multiphase flows in complex porous networks occur in many natural processes and engineering applications. We present an analytical, experimental and numerical investigation of slow drainage in porous media that exhibit a gradient in grain size. We show that the effect of such structural gradient is similar to that of an external force field on the obtained drainage patterns, when it either stabilises or destabilises the invasion front. For instance, gravity can enhance or reverse the drainage pattern in graded porous media. In particular, we show that the width of stable drainage fronts scales both with the spatial gradient of the necessary pressure for pore invasion and with the local distribution of this (disordered) threshold. The scaling exponent results from percolation theory and is − 0.57 for 2D systems. Overall, introducing a dimensionless Fluctuation number, we propose a unifying theory for the up-scaling of dual immiscible fluid flows covering most classical scenarii.