Thien Nguyen

Dr. Thien Nguyen


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 February 2024 in Journal of the Electrochemical Society
Verified
Journal Article
Closed access
PDF file
TNThien Nguyen
Thien Nguyen
HSHongbin Sun
Hongbin Sun
RARuhul Ruhul Amin
Ruhul Ruhul Amin
PRPradeep Ramuhalli
Pradeep Ramuhalli
CKChol-Bum M. Kweon
Chol-Bum M. Kweon
IBIlias Belharouak
Ilias Belharouak
Lithium-ion batteries have been used increasingly as electrochemical energy storage systems for electronic devices and vehicles. It is important to accurately estimate the state of charge (SoC) of a battery management system to control the battery operation to optimize performance, lifetime, and safety. The current work experimentally leverages ultrasonic diagnostic technology to investigate the SoC of lithium-ion batteries during the charge/discharge processes. A cylindrical-type nickel-cobalt-aluminum (NCA)–based 2500mAh 20A (INR18650-25R) battery was used for ultrasonic measurements with various charge/discharge rates of C/10.4, C/5.2, and C/1.3 at constant currents. The ultrasonic signals were analyzed for extracting wave velocity and wave attenuation. For all the testing rates, wave velocity increased in the charge process and decreased in the discharge process. Velocity profiles corresponding to lower rates of C/10.4 and C/5.2 exhibited primary peaks at the maximum SoCs, whereas the absolute wave velocity of C/1.3 rate showed primary peaks that occurred slightly after the SoC peak, indicating a delayed maximum Young's modulus. The wave attenuation computed for the C/10.4 rate had local maxima in the charge and discharge processes and depicted negative correlations with SoC, ranging from 0% to 18%, and positive correlations with SoC from 18% to 85%. On the other hand, the wave attenuation curves of the C/1.3 rate showed no local peaks and had negative correlations with SoC, ranging from 0% to 28%, and positive correlations with SoC ranging from 28% to 53%.

20 August 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
NGNolan Goth
Nolan Goth
TNThien Nguyen
Thien Nguyen
WPWilliam David Pointer
William David Pointer
This study numerically investigated the effects of various contact strategies on the thermal hydraulic behavior within a structured bed of 100 explicitly modeled pebbles. Four contact strategies and two thermal hydraulic conditions were considered. The strategies to avoid contact singularities include decreasing the pebble diameter, increasing the pebble diameter, bridging the pebble surfaces near the contact region, and capping the pebble surfaces near the contact region. One strategy, Strategy 3a, which involves bridging with a cylinder equal to 10% of the pebble diameter, was selected as the baseline strategy because it addressed the contact singularity while minimizing the geometric changes that affect the bed porosity. The two thermal hydraulic conditions were full-power operation (Case 1) and pressurized loss of forced cooling or PLOFC (Case 2). Simulations of the conjugate heat transfer within the structured bed were performed using the Reynolds-averaged Navier–Stokes approach with the realizable k-ϵ turbulence model and two-layer all y+ wall treatment. The thermal-fluid quantities of interest were compared between the contact strategies for each case. In Case 1, the hydraulic behavior was sensitive to the contact strategy, with large differences in the pressure drop (30%) and volume-average velocity (4%). The thermal behavior was not sensitive, with less than a 0.5% difference across the strategies. To better understand the separate effects of each heat transfer mode, Case 2 was divided into the following subcases: conduction (Case 2a); conduction/radiation (Case 2b); and conduction/radiation/convection (Case 2c). Case 2a represents an early phase of the PLOFC transient. Case 2b represents an intermediate phase of the PLOFC transient, with the pebble temperatures sufficiently high for the radiative heat transfer to be non-negligible. Case 2c represents a late phase of the PLOFC transient after the establishment of the natural circulation of the heat transfer fluid. For Case 2, large differences in the contact strategy were observed only in Case 2a with only conduction. The difference in the maximum pebble temperature was 23% in Case 2a, 2% in Case 2b, and 0.3% in Case 2c.

1 September 2025 in Physics of Fluids
Verified
Journal Article
Closed access
TNThien Nguyen
Thien Nguyen
MBMichael Benson
Michael Benson
DBDaniel Borup
Daniel Borup
ABAndrew Banko
Andrew Banko
We studied the flow field characteristics of a turbulent flow over a regularized cube array with a perpendicular injection flow through the floor between the second and third cubical elements, representing the complex flow interactions of a 3D jet and the wake flows behind cubical obstacles. Four different experimental measurements were performed: two magnetic resonance imaging-based measurements for three-dimensional three-component velocity (MRV) and concentration (MRC) and two laser-based techniques, particle image velocimetry (PIV) and planar laser-induced fluorescence (PLIF), for two-dimensional two-component velocity and concentration measurement, respectively. The mainstream Reynolds number is Re=15 000, based on the primary inlet velocity Um and channel height DH, whereas the injector Reynolds number is Rej=3400, based on the injector velocity Uj and the injector's exit width Dj. Numerical simulations were performed for the studied flow configuration of turbulent flow over a regularized cube array using Reynolds-averaged Navier–Stokes (RANS) and large-eddy simulation (LES) approaches. Results obtained from experimental measurements—including MRV, MRC, PIV, and PLIF—as well as RANS and LES simulations are discussed and compared along several horizontal and vertical planes of the studied configuration. In addition, 3D turbulent flow structures, such as leading-edge vortex, horseshoe vortex, and jet shear-layer vortex, and the isosurfaces of scalar concentration successfully revealed by MRV and MRC techniques were found to be in very good agreement with those 3D features extracted from RANS and LES simulations. The high-resolution experimental and numerical database obtained from this study could be useful for validation and verification of numerical codes.

1 December 2025
Verified
Report
Open access
PDF file
TNThien Nguyen
Thien Nguyen
USUsdoe
Usdoe
VRVivek Rao
Vivek Rao
SDScott DeNeale
Scott DeNeale
KSKevin M Stewart
Kevin M Stewart
PLPhong Le
Phong Le
Using existing coal mines to build underground pumped storage hydropower (UPSH) power plants could help reduce the costs associated with starting a new PSH operation. This innovative approach can leverage the existing infrastructure of coal mine facilities available in many regions of the United States. However, technical challenges associated with water quality, mineral chemistry and integrity of subsurface topologies have thus far prevented any of these facilities from going online. Rye Development is investigating the feasibility of UPSH at existing coal mine facilities. In this project, Rye Development received the technical assistance from Oak Ridge National Laboratory to investigate the impacts of minerals, metal particles, and chemical substances in water flow on hydraulic equipment and assess the overall structural integrity of hydraulic equipment in former coal mines.

1 December 2025
Verified
Report
Open access
PDF file
TNThien Nguyen
Thien Nguyen
USUsdoe
Usdoe
WMWilliam Mccarter
William Mccarter
HSHongbin Sun
Hongbin Sun
DODaniel Orea
Daniel Orea
JMJoanna McFarlane
Joanna McFarlane
This document summarizes outcomes and findings from a project sponsored by the Nuclear Safety Research and Development Program, which is managed by the Office of Nuclear Safety, within the Office of Environment, Health, Safety and Security.

1 August 2026
Verified
Report
Open access
PDF file
USUsdoe
Usdoe
DODaniel Orea
Daniel Orea
O(Oak Ridge Oak Ridge National Laboratory (Ornl)
Oak Ridge Oak Ridge National Laboratory (Ornl)
NPNicholas Poole
Nicholas Poole
ZKZechariah Kitzhaber
Zechariah Kitzhaber
NGNolan Goth
Nolan Goth
Much of the radionuclide transport from a molten salt reactor (MSR) during operation may arise from aerosols generated in the pump bowl or from condensation of vaporized species. The Visualizing Insoluble Species and Transport of Aerosols (VISTA) apparatus was used to investigate such aerosol generation, bubble transport, and insoluble species behavior in a molten LiCl-KCl eutectic salt system. The VISTA apparatus provided an optically accessible quartz test cell coupled with simultaneous shadowgraph imaging, particle tracking velocimetry (PTV)/particle image velocimetry (PIV), laser-induced breakdown spectroscopy (LIBS), and high-resolution electrical low-pressure impactor (HR-ELPI+) measurements. Experiments examined the effects of sparging orientation, sparge gas flow rate, and cover gas sweep rate on bubble behavior and aerosol transport. Baseline tests were conducted with LiCl-KCl, followed by tests in which 2.6 µm Ni powder was introduced as an insoluble species. In a first-of-a-kind experiment, hybrid PIV-PTV measurements captured the motion of dispersed aerosols within the test cell cover gas region. These measurements led to velocity estimations. The HR-ELPI+ measurements indicated that the cumulative aerosol response generally increased with both sparge and sweep flow rate. Number-based particle size distributions were dominated by an ultrafine mode, with geometric mean diameters (GMDs) of approximately 0.024 µm to 0.027 µm, whereas the estimated mass distributions were dominated by larger particles with GMDs of approximately 4.7 µm to 4.8 µm. These results demonstrate that a relatively small population of coarse particles indicate aerosol mass even when ultrafine particles dominate the particle number distribution. LIBS detected Ni spectral features during sparging, with signal intensity increasing as the Ni concentration increased from 0.01 mol % to 0.03 mol %. Cascade impactor analysis further indicated that Ni-containing salt enabled the transport of greater mass than Ni-free salt. The increased aerosol mass collected was higher than what could be solely attributed to the higher density of Ni. These results support the use of combined optical, spectroscopic, and aerosol measurements for characterizing radionuclide transport and informing MSR off-gas and source term models. Experience gained from VISTA experiments will be used to prepare for the more challenging fluoride salt analyses, for which the use of quartz cells is not feasible. These experiments have started to address the challenge of measuring the transport of particles in molten salt media—a challenge relevant to the tracking of noble metal fission products in MSRs.