The ecotoxicity of a set of 30 ionic liquids, namely 23 aprotic compounds (APILs) and 7 protic compounds (PILs), was analyzed in this work by monitoring the inhibition of the bioluminescence of the bacteria Aliivibrio fischeri with varying concentrations of ILs utilizing the Microtox^® standard toxicity test. The study covered ILs that have various synthetic natures, PILs and APILs, with a common anion or cation, and different alkyl chain lengths. The results indicate that both moieties, anion and cation, have an influence on toxicity, these being the ILs with the bis((trifluoromethyl)sulfonyl)imide (TFSI) anion and imidazolium cation, which are the most harmful, while those less toxic correspond to ammonium-based ILs. The alkyl chain length seems to have the most significant impact on toxicity, except for tris(pentafluoroethyl) trifluorophosphate (FAP) anion-based ILs, which, interestingly, showed the opposite behavior. A critical alkyl size (CAS) at C = 6 was observed for the rest of the families, resulting in a significant reduction in the effective concentration (EC) values: the connection between this CAS and toxicity has never been observed before, and it indicates a threshold that marks the end of harmlessness (C < 6) and the start of toxicity (C > 6).

In the current context of increasing energy demand, ionic liquids (ILs) are presented as possible candidates to replace conventional electrolytes and to develop more efficient energy storage devices. The IL 1-Methyl-1-propylpyrrolidinium bis(trifluoromethanesulfonyl)imide has been selected for this work, due to the good thermal and chemical stabilities and good electrochemical performance of the pyrrolidinium cation based ILs. Binary mixtures of this IL and lithium salt with the same anion, [TFSI], have been prepared with the aim of assessing them, as possible electrolytes for lithium batteries. These mixtures were thermally and electrochemically characterised through DSC and dielectric spectroscopy studies. The ionic conductivity decreases as the salt concentration increases, finding values ranging between 0.4 S/m and 0.1 S/m at room temperature. Additionally, a wide liquid range was found for the mixtures, which would reduce or even eliminate some of the most common problems of current electrolytes, such as their crystallisation at low temperatures and flammability. Finally, the toxicity of pure IL and the intermediate salt concentration was also evaluated in terms of the bioluminescence inhibition of the Alivibrio Fischeri bacteria, observing that, although the toxicity increases with the salt addition, both samples can be classified as practically harmless.

Due to their intrinsic properties, the current applicability of ionic liquids is enormous. In particular, their use in electrochemistry is beyond question. Numerous studies on these compounds and their mixtures, especially with lithium salts, focus on their use as electrolytes for batteries and other energy storage devices. This includes thermal energy storage devices, where 4th generation ionic liquids and their derivatives show a huge potential. Nevertheless, considering the uneven availability of the raw materials, such as lithium, research has extended to mixtures of these compounds with other salts of different metals that are more abundant and widely distributed, such as magnesium or aluminum. This work presents a comprehensive thermal characterization, using differential scanning calorimetry and thermogravimetry, of the protic ionic liquid ethylimidazolium nitrate and its mixture with magnesium and aluminum nitrate salts at different concentrations. Additionally, a comparison between these results and previous studies of mixtures of this ionic liquid with lithium nitrate, as well as mixtures of the protic ionic liquid EAN with the same metal salts, was also performed. The results indicated that the salt addition tends to broaden and reduce crystallization and melting peaks, while the glass transition becomes more visible and shifts to higher temperatures with increasing salt concentration. This is due to the disorder generated by the rearrangement of ions in the polar domains, which erodes the hydrogen bond network of the protic ionic liquid. Nevertheless, the thermal stability of the blended samples does not change significantly compared to the bulk ionic liquid.

Over the past few decades, ionic liquids (ILs) have gained attention as electrolytes, although concerns about their environmental persistence and toxicity challenge their status as green solvents. In this framework, choline chloride (ChCl) offers a more sustainable alternative due to its low toxicity, biodegradability, and cost-effectiveness. Although ChCl has a high melting point, its combination with hydrogen bond donor compounds (HBDs) can result in liquid mixtures at much lower temperatures, known as deep eutectic solvents (DESs). This study presents a comparative evaluation of three ChCl-based DESs, glyceline, ethaline, and reline (obtained from mixtures of ChCl and glycerol, ethylene glycol, and urea), with a focus specifically on their potential as electrolyte candidates for supercapacitors. Using differential scanning calorimetry (DSC), cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), and nuclear magnetic resonance (NMR), we assess their thermal, electrochemical, and structural properties. All DESs displayed amorphous behavior and a strong tendency to remain liquid even at very low temperatures. Among them, ethaline showed the most promising electrochemical performance, exhibiting the lowest resistivity and the highest capacity.

Ionic liquids (ILs) have attracted increasing attention due to their unique physicochemical properties. Among them, 1-Methyl-1-propylpyrrolidinium bis(trifluoromethanesulfonyl)imide, emerges as an ideal candidate for fundamental studies in electrochemical applications. This work aims to deepen the understanding of its conductivity performance, and potential interaction with added metal salts, providing insight into its applicability in advanced energy storage systems. Firstly, binary mixtures with ethylene carbonate have been prepared to improve the transport properties and select the optimal concentration of both components. Subsequently, lithium salt was added to design the adequate electrolyte. The thermal and electrochemical characterisation of these mixtures was performed by differential scanning calorimetry (DSC) thermogravimetric analysis (TGA) and Broad Band Dielectric Spectroscopy (BBDS). The results reveal a wide liquid range for the ternary systems studied, extending below −80 °C and above 120 °C. Additionally, they exhibit notably high conductivity values at room temperature (ranging from 0.2 S·m⁻¹ for the most concentrated to 0.70 S·m⁻¹ for the lowest concentrated), which highlights their suitability for advanced electrochemical applications, including but not limited to batteries. This extended liquid phase mitigates, or potentially eliminates, some of the most common issues associated with current electrolytes, such as undesired crystallisation at low temperatures. In this paper, a new promising electrolyte, consisting of a ternary mixture obtained by adding lithium salt to the eutectic composition of [C₃C₁Pyrr][TFSI] and ethyl carbonate is proposed.

Ionic Liquids (ILs) are composed of ions, usually an organic cation with an organic or inorganic anion, with a melting point below 100 °C and in most cases below room temperature. These compounds exhibit important and characteristic properties such as high ionic conductivity, good thermal and electrochemical stability and low toxicity and flammability. Subsequently, ILs have been studied as promising substitutes for conventional electrolytes for electrochemical applications, both as bulk liquids or confined in polymer matrices, commonly known as ionogels, which have the advantages of not leaking and enhancing safety and manipulation during device assembly. For this work, the ionogel of the IL 1-Ethyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([C₂C₁Im][TFSI]) was synthesized by the polymerization of Tetramethyl orthosilicate (TMOS) and Dimethyldimethoxysilane (DMDMS). Thermal analyses of the pure ionic liquid and electrochemical response of the ionogel were studied in comparison with the corresponding bulk IL by using differential scanning calorimetry (DSC), thermogravimetry (TGA) and broad-band dielectric spectroscopy (BBDS), respectively.