A high-frequency, piezoelectric thin-film sensor was successfully deposited on a nickel-based superalloy bolt by radio frequency magnetron sputtering to develop a smart, nickel-based superalloy bolt. Ultrasonic response characterization, high accuracy, and repeatability of ultrasonic measurement of axial preload in nickel-based superalloy smart bolts are reported here and were fully demonstrated. The axial preload in the nickel-based superalloy smart bolt was directly measured by the bi-wave method (TOF ratio between transverse and longitudinal-mode waves) without using the traditional integration of a longitudinal and shear transducer. A model concerning the bolt before and after tensioning was established to demonstrate the propagation and displacement distribution of the ultrasonic waves inside a nickel-based superalloy smart bolt. The measured A-scan signal presented significantly favorable features including a mixture of transverse and longitudinal mode waves, a pure and broad frequency spectrum which peaked at 17.14 MHz, and high measurement accuracy below 3% for tension of 4 kN–20 kN. For the temporal ultrasonic signal, the measurement envelopes were narrower than for the counterpart of the simulation, justifying the ‘filtration’ advantage of the high-frequency sensor. Both the TOF change of the single longitudinal-mode wave and the TOF ratio between transverse- and longitudinal-mode waves increased linearly with preload force in the range of 0 kN to 20 kN. Compared with the commercial piezoelectric probe, the proposed probe, based on the combination of a high-frequency, piezoelectric thin-film sensor and a magnetically mounted transducer connector, exhibited high tolerance to temperatures as high as 320 °C and high repeatability free from some interference factors such as bolt detection position change and couplant layer thickness. The results indicate that this system is a promising axial preload measurement system for high-temperature fasteners and connectors, and the proposed sensor is a practical, high-frequency ultrasonic sensor for non-destructive testing.
Molecular oxygen activated by visible light to generate radicals with high oxidation ability exhibits great potential in environmental remediation The efficacy of molecular oxygen activation mainly depends on the separation and migration efficiency of the photoinduced charge carriers. In this work, 2D/2D CdIn2S4/g-C3N4 heterojunctions with different weight ratios were successfully fabricated by a simple electrostatic self-assembled route. The optimized sample with a weight ratio of 5:2 between CdIn2S4 and g-C3N4 showed the highest photocatalytic activity for tetracycline hydrochloride (TCH) degradation, which also displayed good photostability. The enhancement of the photocatalytic performance could be ascribed to the 2D/2D heterostructure; this unique 2D/2D structure could promote the separation and migration of the photoinduced charge carriers, which was beneficial for molecular oxygen activation, leading to an enhancement in photocatalytic activity. This work may possibly provide a scalable way for molecular oxygen activation in photocatalysis.