Inverted perovskite solar cells (PSCs) have attracted considerable attention due to their distinct advantages, including minimal hysteresis, cost‐effectiveness, and suitability for tandem applications. Nevertheless, the solution processing and the low formation energy of perovskites inevitably lead to numerous defects formed at both the bulk and interfaces of the perovskite layer. These defects can act as non‐radiative recombination centers, significantly impeding carrier transport and posing a substantial obstacle to stability and further enhancing power conversion efficiency (PCE). This review delves into a detailed discussion of the nature and origin of defects and the characterization techniques employed for defect identification. Furthermore, it systematically summarizes methods for defect detection and approaches for passivating interface and bulk defects within the perovskite film in inverted PSCs. Finally, this review offers a perspective on employing upscaling defect passivation engineering for perovskite modules. It is hoped this review provides insights into defect passivation in inverted PSCs and solar modules.
8 March 2024 in Journal of the American Chemical Society
Inverted perovskite solar cells (PSCs) are preferred for tandem applications due to their superior compatibility with diverse bottom solar cells. However, the solution processing and low formation energy of perovskites inevitably lead to numerous defects at both the bulk and interfaces. We report a facile and effective strategy for precisely modulating the perovskite by incorporating AlOx deposited by atomic layer deposition (ALD) on the top interface. We find that Al3+ can not only infiltrate the bulk phase and interact with halide ions to suppress ion migration and phase separation but also regulate the arrangement of energy levels and passivate defects on the perovskite surface and grain boundaries. Additionally, ALD‐AlOx exhibits an encapsulation effect through a dense interlayer. Consequently, the ALD‐AlOx treatment can significantly improve the power conversion efficiency (PCE) to 21.80 % for 1.66 electron volt (eV) PSCs. A monolithic perovskite‐silicon TSCs using AlOx‐modified perovskite achieved a PCE of 28.5 % with excellent photothermal stability. More importantly, the resulting 1.55 eV PSC and module achieved a PCE of 25.08 % (0.04 cm2) and 21.01 % (aperture area of 15.5 cm2), respectively. Our study provides an effective way to efficient and stable wide‐band gap perovskite for perovskite‐silicon TSCs and paves the way for large‐area inverted PSCs.