Hurricane events combine ocean storm surge penetration with inland runoff flooding. This article presents a new methodology to determine coastal flood levels caused by the combination of storm surge and surface runoff. The proposed approach couples the Simulating Waves Nearshore model and the Advanced Circulation (ADCIRC) model with the Gridded Surface Subsurface Hydrologic Analysis (GSSHA) two-dimensional hydrologic model. Radar precipitation data in a 2D hydrologic model with a circulation model allows simulation of time and spatially varied conditions. The method was applied to study flooding scenarios occurring during the passage of Hurricane Georges (1998) on the east coast of Puerto Rico. The combination of storm surge and surface runoff produced a critical scenario, in terms of flood depth, at this location. The paper describes the data collection process, circulation and hydrologic models, their assemblage and simulation scenarios. Results show that peak flow from inland runoff and peak flow due to storm surge did not coincide in the coastal zone; however, the interaction of both discharges causes an aggravated hazardous condition by increasing flood levels beyond those obtained with storm surge penetration only. Linking of storm surge and hydrologic models are necessary when storm surge conditions occur simultaneously with high precipitation over steep and small coastal watersheds.
Low‐gradient coastal watersheds are susceptible to flooding caused by various flows such as rainfall‐runoff, astronomical tides, storm surges, and riverine flows. Compound flooding occurs when at least one coastal flood driver occurs simultaneously or in close succession with a pluvial and/or fluvial flood driver, such as during a tropical cyclone event. This study presents a one‐dimensional (1‐D), reduced‐order physics compound inundation model tested over an idealized coastal watershed transect under various forcing conditions (e.g., coastal and pluvial) that varied in magnitude, time, and space. This study aims to evaluate each flooding mechanism and the associated hydrodynamic responses by performing a sensitivity analysis and developing a non‐linear equation that could correlate the flood drivers with the severity of its flood. Compound inundation levels are affected by the magnitude and timing of each flooding mechanism. Results highlight the need to consider momentum exchange during a compound event and the importance of reduced‐physics approaches that can improve the interaction between flood drivers when paired with a moving coupling node approach. The desire is a more holistic compound inundation model that can be a critical tool for decision‐makers, stakeholders, and authorities who provide evacuation planning to save human lives and enhance resilience.
1 June 2019 in Journal of Irrigation and Drainage Engineering
There is a need for regulation and control of irrigation conveyance systems for sustainable agriculture. Design and analysis of hydraulic structures within complex channel systems are essential for conservation and efficient use of irrigation water. An improved computational model based on gradually varied flow assumptions and capable of solving discharges and water levels in complex channel network systems to include lateral weirs is presented. Results include water levels, discharge distribution, and computation of flow over or dimensions of lateral structures. The model uses the simultaneous solution method (SSM) to solve the continuity and energy equations at several channels reaches, in addition to the lateral weir equation. The nonlinear system of equations produced when applying this method is solved with the Newton-Raphson procedure. A series of successive approximations leading to the solution requires the solution of a set of linear equations. The biconjugated gradient stabilizer with preconditioner method (BiCGSTAB) is used to solve the linear system formed by large sparse matrices occurring in channel networks. Comparison of the SSM results with the standard step method (StdSM) as included in Hydrologic Engineering Center-River Analysis System (HEC-RAS) for parallel channel systems, with and without lateral structures, was excellent. The capabilities of the SSM are demonstrated solving a channel network in which three lateral weirs are designed and two more are analyzed during the same program execution. The model is easy to use, converges in a few iterations, and can be applied for design or analysis of lateral structures in irrigation engineering.
26 May 2026 in Journal of Environmental Management
Low-gradient coastal watersheds are susceptible to flooding caused by various flows such as rainfall-runoff, astronomical tides, storm surges, and riverine flows. Compound flooding occurs when at least one coastal flood driver occurs simultaneously or in close succession with a pluvial and/or fluvial flood driver, such as during a tropical cyclone event. This study presents a one-dimensional (1-D), reduced-order physics compound inundation model tested over an idealized coastal watershed transect under various forcing conditions (e.g., storm surge, astronomical tides, and rainfall) that varied in magnitude, time, and space. This study aims to evaluate each flooding mechanism and the associated hydrodynamic responses to identify generalized coastal transition zones and enhance the production of flood maps for varying regions in a coastal watershed. Compound inundation levels are affected by the magnitude and timing of each flooding mechanism. The desire is a more holistic compound inundation model that can be a critical tool for decision-makers, stakeholders, and authorities who provide evacuation planning to save human lives and enhance resilience.