Sarah Green

Prof. Dr. Sarah Green

orcid

Research Focus & Metrics

Academic Career Length

34Years (1993-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 March 2007 in Injury
Verified
Journal Article
Closed access
MAM. Ahmad
M. Ahmad
RNR. Nanda
R. Nanda
ABA.S. Bajwa
A.S. Bajwa
JCJ. Candal-Couto
J. Candal-Couto
SGSarah Green
Sarah Green
AHA.C. Hui
A.C. Hui

1 January 1997 in Powder Metallurgy
Verified
Journal Article
Closed access
SGSarah Green
Sarah Green
David GrantDavid Grant
David Grant
NKN. R. Kelly
N. R. Kelly
The near net shape production of homogeneous Ni–Ti intermetallic displaying good shape memory behaviour is attractive, particularly for potential biomaterials applications. This study investigates and characterises equiatomic Ni–Ti shape memory alloy prepared by the compaction and sintering of elemental Ti and Ni powders. Phase development during sintering was determined using X–ray diffraction, scanning electron microscopy, and energy dispersive X-ray analysis, and dimensional integrity ,of the compacts was monitored during sintering. The shape memory behaviour of the Ni–Ti compacts was assessed using differential scanning calorimetry. Employment of a combined solid state and liquid phase sinter cycle produced homogeneous Ni–Ti intermetallic containing 35% porosity and displaying shape memory transformation enthalpy similar to that of commercially produced wrought Ni–Ti material. PM/0746

1 April 2015 in Environmental Technology & Innovation
Verified
Journal Article
Closed access
ASAdeayo Sotayo
Adeayo Sotayo
SGSarah Green
Sarah Green
GTGeoffrey Turvey
Geoffrey Turvey

1 March 1997 in Materials Science and Engineering: A
Verified
Journal Article
Closed access
SGSarah Green
Sarah Green
David GrantDavid Grant
David Grant
JWJ.V. Wood
J.V. Wood

1 June 2001 in Proceedings of the Institution of Mechanical Engineers, Part H: Journal of Engineering in Medicine
Verified
Journal Article
Closed access
SSS C Scholes
S C Scholes
SGSarah Green
Sarah Green
AUA Unsworth
A Unsworth
New generation metal-on-metal prostheses have been introduced to try and overcome the problem of osteolysis often attributed to the wear particles of the polyethylene component of conventional metal-on-ultra-high molecular weight polyethylene (UHMWPE) joints. The wear rates of four metal-on-metal joints (two different clearances) were assessed along with that of a conventional metal-on-UHMWPE joint. Friction measurements of the metal-on-metal joints were taken before and after the wear test and compared. Two distinct wear phases were discernible for all the metal-on-metal joints: an initial wear phase up to 0.5 × 106 cycles and then a lower steady state wear phase. The steady state wear rate of the 22 μUm radial clearance metal-on-metal joint was lower than that for the 40 μUm radial clearance joint, although this difference was not found to be significant ( p > 0.15). The wear rates for all the joints tested were consistent with other simulator studies. The friction factors produced by each joint were found to decrease significantly after wear testing ( p < 0.05).

1 March 1995 in Acta Metallurgica et Materialia
Verified
Journal Article
Closed access
David GrantDavid Grant
David Grant
SGSarah Green
Sarah Green
JWJ.V. Wood
J.V. Wood