The present study investigates the significance of pre-strain on the T6 aging behavior of an Al 7075 alloy for evaluating the applicability of hot stamping. In practice, the alloy was pre-strained up to 15% during solution heat treatment at 480 °C prior to quenching, and artificial aging was conducted at 120 °C. The peak aging time and precipitation behavior were compared with the alloy with pre-straining at room temperature after quenching but immediately before the artificial aging. The results showed that increasing amounts of pre-strain tend to reduce the aging time up to 50% for achieving peak hardness, which is consistent with the alloy at the T6 condition. There is a limitation for the maximum attainable amount of pre-strain of 10% for the homogeneous distribution of strain when the alloy is strained at room temperature (RT) due to the low formability. The pre-strained alloy as hot stamping exhibited lowering of the peak reaction temperatures for dissolution and formation of Guinier–Preston (GP)-Zones and precipitated with increasing amounts of pre-strain towards 15% through the differential scanning calorimetry analysis, thereby confirming the shortening of the peak aging time. The present study confirms the excellent potential of the hot-stamping process to extend the capability of an Al 7075 alloy.

The surface quality control of extruded products is a critical concern in the home appliance manufacturing industry owing to the increasing need for products with a high surface quality, in addition to the essential mechanical properties of the final product. The underlying issue with achieving high-quality extrusion products is that surface defects, especially those resulting in surface gloss differences, called white line defects, are only observed after surface treatment. In this study, we aim to investigate the cause of white line defect generation on the surface of an extruded product. Accordingly, an experimental extrusion program is established using an L-shaped die that has a noticeable change in its bearing length along the inner corner of its cross-sectional profile. Laboratory-scale experiments were performed for the L-shaped extrusion of homogenized Al 6063 alloy at various ram speeds, in order to induce surface defects, considering the production yield rate required for mass production. Subsequently, the microstructural changes near the surface failure region were investigated using an arbitrary Lagrangian–Eulerian (ALE) technique-based thermomechanical finite element (FE) analysis. To scale-up the defect observation method from laboratory-scale to production-scale manufacturing and confirm the reproducibility of the surface defect, scaled-up L-shaped extrusions were performed in an actual industrial production line. Finally, the potential cause of white line defect generation is discussed by comparing the numerical and metallurgical analyses, including the scanning electron microscopy (SEM) and electron backscatter diffraction (EBSD) observations.

This study was carried out to observe and measure the microstructure, distance between dendrite arms, aspect ratio, and Knoop hardness change of extruded material formed by the hydro co-extrusion of Al3003/Al4004 clad material manufactured by the duo-casting method. The specimen of duo-casted Al3003/Al4004 clad materials was circle shaped; it was composed of Al3003 (outside) and Al4004 (inside) materials. The manufacturing conditions of the hydro co-extruded specimen were 423 K temperature and 6.5 ratio of extrusion. At the interface of the duo-casted Al3003/Al4004 clad material, a non-junction at the interface and non-metallic inclusions of Si- and Mn-based oxides were observed. Al3003 exhibits equiaxed crystals; Al4004 has a casted structure with dendrites before extrusion, showed slight deformation during extrusion, and then finally exhibited completely deformed structures after extrusion. In the cast material, the distance between dendrite arms increased, and the aspect ratio of dendrites tended to decrease from the surface to the center. However, in the case of the extruded material, neither Al3003 nor Al4004 changed significantly from the surface to the inside. As extrusion progressed, the Knoop hardness value at the interface of Al3003/Al4004 increased rapidly compared with those of Al3003 and Al4004 matrixes.