Giuseppe Di Giulio

Dr. Giuseppe Di Giulio

orcid

Research Focus & Metrics

Academic Career Length

18Years (2009-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
10 October 2009 in Journal of Geophysical Research
Verified
Journal Article
Closed access
PDF file
GGGiuseppe Di Giulio
Giuseppe Di Giulio
FCF. Cara
F. Cara
ARA. Rovelli
A. Rovelli
GLG. Lombardo
G. Lombardo
RRR. Rigano
R. Rigano

23 May 2022 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
MVMaurizio Vassallo
Maurizio Vassallo
GCGiovanna Cultrera
Giovanna Cultrera
GGGiuseppe Di Giulio
Giuseppe Di Giulio
FCFabrizio Cara
Fabrizio Cara
GMGiuliano Milana
Giuliano Milana
We analyzed 12 years of continuous seismic data acquired by two seismic stations in Central Apennines (Italy) with the aim to investigate the temporal variations of H/V spectral ratios. The two stations are located in the epicentral areas of the main strong motion earthquakes occurred in Central Italy in the last 12 years (L’Aquila 06 April 2009, Mw 6.1; Amatrice 24 August 2016, Mw 6.0; Visso 26 October 2016, Mw 5.9, and Norcia 30 October 2016, Mw 6.5). H/V ratios are computed both on continuous and earthquakes data recorded by the two stations. H/V ratios are subjected to abrupt changes after strong earthquakes. The results highlight that after strong shaking, there are remarkable drops of the peak frequencies (7%–10% of reduction). After this sudden decrease, the peak frequency slowly recovers to the initial value in a time ranging from a few months to a few years. We also observe a moderate frequency variation (of order of 2%–3%) linked to seasonal variations: the peak frequencies increase in the spring‐summer months and decrease during the winter. The frequency changes after strong earthquakes have been interpreted in terms of velocity variations of the shallow layers. This effect must be taken into account for microzonation, geophysical, and engineering studies that are often carried out in the epicentral areas after strong earthquakes. H/V analysis over time proved to be a useful procedure for highlighting temporal changes relating to the properties of shallow layers of the propagation medium and could provide relevant information for the site characterization of permanent seismic stations.

16 June 2021 in Bulletin of Earthquake Engineering
Verified
Journal Article
Open access
PDF file
GGGiuseppe Di Giulio
Giuseppe Di Giulio
GCGiovanna Cultrera
Giovanna Cultrera
CCCécile Cornou
Cécile Cornou
PBPierre-Yves Bard
Pierre-Yves Bard
BTBilal Al Tfaily
Bilal Al Tfaily
Many applications related to ground-motion studies and engineering seismology benefit from the opportunity to easily download large dataset of earthquake recordings with different magnitudes. In such applications, it is important to have a reliable seismic characterization of the stations to introduce appropriate correction factors for including site amplification. Generally, seismic networks in Europe describe the site properties of a station through geophysical or geological reports, but often ad-hoc field surveys are missing and the characterization is done using indirect proxy. It is then necessary to evaluate the quality of a seismic characterization, accounting for the available site information, the measurements procedure and the reliability of the applied methods to obtain the site parameters.In this paper, we propose a strategy to evaluate the quality of site characterization, to be included in the station metadata. The idea is that a station with a good site characterization should have a larger ranking with respect to one with poor or incomplete information. The proposed quality metric includes the computation of three indices, which take into account the reliability of the available site indicators, their number and importance, together with their consistency defined through scatter plots for each single pair of indicators. For this purpose, we consider the seven indicators identified as most relevant in a companion paper (Cultrera et al. 2021): fundamental resonance frequency, shear-wave velocity profile, time-averaged shear-wave velocity over the first 30 m, depth of both seismological and engineering bedrock, surface geology and soil class.

25 November 2015 in Geophysical Journal International
Verified
Journal Article
Open access
PDF file
GGGiuseppe Di Giulio
Giuseppe Di Giulio
RNRita de Nardis
Rita de Nardis
Paolo BoncioPaolo Boncio
Paolo Boncio
GMGiuliano Milana
Giuliano Milana
GRGianluigi Rosatelli
Gianluigi Rosatelli
GLGiusy Lavecchia
Giusy Lavecchia
The Sulmona plain (central Italy) is an intramontane basin of the Abruzzi Apennines that is known in the literature for its high seismic hazard. We use extensive measurements of ambient noise to map the fundamental frequency and to detect the presence of geological heterogeneities in the basin. We perform noise measurements along two basin-scale orthogonal transects, in conjunction with 2-D array experiments in specific key areas. The key areas are located in different positions with respect to the basin margins: one at the eastern boundary (fault-controlled basin margin) and one in the deepest part of the basin. We also collect independent data by using active seismic experiments (MASW), down-hole and geological surveys to characterize the near-surface geology of the investigated sites. In detail, the H/V noise spectral ratios and 2-D array techniques indicate a fundamental resonance (f0) in the low-frequency range (0.35–0.4 Hz) in the Sulmona Basin. Additionally, our results highlight the important role that is played by the alluvial fans near the edge-sectors of the basin, which are responsible for a velocity inversion in the uppermost layering of the soil profile. The H/V ratios and the dispersion curves of adjacent measurements strongly vary over a few dozens of meters in the alluvial fan area. Furthermore, we perform 1-D numerical simulations that are based on a linear-equivalent approach to estimate the site response in the key areas, using realistic seismic inputs. Finally, we perform a 2-D simulation that is based on the spectral element method to propagate surface waves in a simple model with an uppermost stiff layer, which is responsible for the velocity inversion. The results from the 2-D modelling agree with the experimental curves, showing deamplified H/V curves and typical shapes of dispersion curves of a not normally dispersive site.

3 January 2019 in Tectonics
Verified
Journal Article
Open access
PDF file
FVFabio Villani
Fabio Villani
Vincenzo SapiaVincenzo Sapia
Vincenzo Sapia
PBPaola Baccheschi
Paola Baccheschi
RCRiccardo Civico
Riccardo Civico
GGGiuseppe Di Giulio
Giuseppe Di Giulio
DPD. Pantosti
D. Pantosti
The Pian Grande di Castelluccio (PGC) basin is the main Quaternary depocenter of the Mt. Vettore‐Mt. Bove normal fault system (VBFS), responsible for the 30 October 2016 Mw 6.5 Norcia earthquake (central Italy). Coseismic surface faulting through the basin attests the occurrence of active splays of the seismogenic master fault; thus, we explore the subsurface basin structure to infer the long‐term behavior of the VBFS. We integrate electrical resistivity tomography (ERT), time domain electromagnetic soundings (TDEM), and horizontal‐to‐vertical spectral ratios of ambient seismic vibrations (HVSR) along a transect crossing the surface ruptures. The ERT models provide high‐resolution details of three shallow fault zones. One‐dimensional resistivity models from TDEM and HVSR frequency peaks suggest abrupt steps in the top bedrock caused by previously unknown faults and indicate an infill thickness of up to ~300 m. We also analyze shear wave splitting of S phases (fast direction φ and delay time δt) from local earthquakes recorded during our surveys to better constrain the fracture field and the properties of the inferred fault zones. We relate the retrieved pattern of fault‐parallel φ, and the associated larger δt, to the main and secondary faults in the upper crust and to the cracks or shear fabric in the damage zones of the active splays. The PGC basin is due to the interference of an older N30° striking fault system subsequently crosscut by the N150° striking VBFS, which is currently active, seismogenic, and capable of rupturing the surface during M > 6 earthquakes.

24 March 2018 in Bulletin of Earthquake Engineering
Verified
Journal Article
Closed access
PDF file
SASara Amoroso
Sara Amoroso
IGIolanda Gaudiosi
Iolanda Gaudiosi
Marco TalliniMarco Tallini
Marco Tallini
GGGiuseppe Di Giulio
Giuseppe Di Giulio
GMGiuliano Milana
Giuliano Milana