The integrated sensing and communication is emerging as a crucial technology due to reduced hardware costs and broad application scenarios. However, there is a contradiction between ranging and communication in phase-shift light detection and ranging (LiDAR) for the utilization of the subcarrier’s phase. A scheme called phase-shift laser ranging with communication (PLRC) is proposed to enable both ranging and communication using the same transmitted signal in this paper. The message encoded with pseudo-random noise code is modulated into the phase of the subcarrier for laser emission, and thus the received signal carries the data and the phase difference due to the distance. The received signal is subject to correlation, waveform recovery, and phase-shift measurement with the local signal at the LiDAR transceiver, and the distance is derived from the complete phase to avoid range ambiguity. The data is extracted from the spread spectrum signal at the communication receiver. The performance in terms of the measured distance and precision of LiDAR, the bit error rate of communication is obtained for the proposed solution. Meanwhile, the optimized light ratio for ranging and communication is derived. The experimental demonstration is carried out, the range precision is 3.54 × 10 -3 m, and the communication capability meets 1.43 Mbit/s.
7 November 2022 in Journal of Lightwave Technology
When the light detection and ranging (LiDAR) scans a space, the echo signal affected by diffuse reflections may be captured by other LiDAR detectors to interfere with their echoes. The ghost points and missed detections are induced by the co-frequency interference in the phase-shift LiDAR. An interference cancellation with a maximum likelihood estimation (ICMLE) signal processing scheme is presented based on the coded phase-shift LiDAR to avoid mutual interference in this paper. The delay time is estimated with maximum likelihood estimation after each component signal is identified from the mixed signal on account of the correlation between the codewords, followed by cancellation of the component signal from the mixed signal step-by-step. The received signal model with mutual interference is developed, and the Cramer-Rao bound (CRB) is theoretically derived to evaluate the performance of the estimators. The Monte-Carlo analysis shows that the component signals can be recognized from the mixed signal with the ICMLE scheme. The mean square error (MSE) of the delay time for the mutual interference of two-channel signals is close to the CRB. The experimental results demonstrate that the ranging is feasible with a range precision of 8.44 × 10 $^{-3}$ m using the echo signal estimated by the proposed solution.
The Faraday rotation and ellipticity spectra of rubidium transition in a magnetic field have been calculated and experimentally measured. By using the rotating quarter-wave plate method, the Stokes parameters of the near-resonant probe light are measured to obtain the Faraday rotation and the ellipticity. The variation of the rotation and the ellipticity spectra is analyzed in different magnetic fields, temperatures, and pump powers. The polarization rotation over 50 deg in 1529 nm with negligible elliptical distortion is obtained. Our study of the Faraday effect between excited states of atoms broadens the available wavelength of the Faraday effect in applications.
A fully digital control scheme for non-polarization-maintaining (non-PM) nanosecond pulse coherent beam combining (CBC) is proposed, where digital locking of optical coherence by single-detector electronic-frequency tagging (LOCSET) for active phase control and stochastic parallel gradient descent (SPGD) for active polarization control is proposed. The fully digital control scheme is integrated on a real-time field-programmable gate array (FPGA) empowered hardware platform and then experimentally validated in a four-channel all-fiber non-fully polarization-maintaining nanosecond pulse CBC system. Consequently, the system can be fully locked in 9.5 ms, and the polarization extinction ratio (PER) of the combined beam is 21.5 dB with a CBC efficiency of 95.3%. The fully digital control scheme integrates the advantages of digital LOCSET and multi-channel active polarization control, enhancing the channel scalability and the potential output power of the non-PM pulse CBC system.
The polarization direction-dependent SBS threshold was investigated, and the terminal polarization control technique was demonstrated to restore the linear polarization state. By increasing the relative angle of the injecting polarization direction from 0° to 90°, the measured SBS threshold increased until reaching a maximum value, beyond which it decreased in a nearly symmetrical trend. The highest SBS threshold was achieved with the relative polarization angle being 45°, delivering a 67% threshold enhancement compared with that at 0°. A quarter-wave-plate was used to restore the polarization state of the output laser manually from an elliptic to a linearly polarized state, and temperature-dependent polarization fluctuation was observed, which intensified as the laser power was scaled. By reducing the cooling temperature, a 1 kW laser with a linearly polarized state was demonstrated using a 45° polarization direction-injected monolithic PM amplifier.
The optimal detuning of the pump light at the rubidium D2 line is calculated and experimentally validated. A three-level optically end-pumped model in a hot rubidium vapor cell is demonstrated, which takes into account the hyperfine structure of the ground state, various collisional processes, and the nonlinear absorption of the pump light along the cell length. By developing a constrained optimization model, we calculate the optimal detuning of the pump light that maximizes the average excited state atom concentration in the cell. Experimentally, a 1529 nm probe light at higher levels, which is attenuated to the weak-probe limit, is introduced to accurately characterize the excited state atom concentration. Coupling with the experimental results, the variation of the pump light optimal detuning with the temperature and the pump light intensity at the unsaturated pumping is analyzed. At the optimal detuning point, the theoretical decay function of the pump light percentage along the vapor cell length almost coincides regardless of the temperature and the pump light intensity changes. Moreover, the theoretical fitted pump light decay function at optimal detuning is predicted. The fitted pump light percentage exiting the vapor cell is 4.75%. A fast implementation method to achieve the maximal average excited state atom concentration in the experiment is demonstrated.