We propose a simple method to mitigate the cross phase modulation (XPM) effect in wavelength division multiplexing (WDM) systems, which combines the split nonlinearity compensation (NLC) and the receiver-side phase recovery algorithm. In the proposed method, the split NLC can suppress the conversion from the nonlinear phase noise (NLPN) to the Gaussian-like nonlinear interference noise (NLIN), and together with the phase recovery algorithm, which can compensate for the NLPN, the impact of the XPM on the signal is finally mitigated. This method is demonstrated by a transmission simulation with 11 WDM channels and 32 Gbaud 16QAM modulations. The simulation results show that, due to the XPM mitigation, the proposed method can provide 0.4 dB gain for 500-km transmission, 0.3 dB gain for 2000-km transmission, and about 0.2 dB gain for 3000-km to 10000-km transmissions. The influence of the transmission distance on the gain is also discussed. Moreover, the selection of the phase recovery algorithm for different transmission distances is investigated, and the results show that for a short distance the blind phase search (BPS) is better, but for a long distance the V&V algorithm is more appropriate.
The backscattering noises introduced by Rayleigh and stimulated Brillouin scattering have been experimentally studied by means of their spectrum broadening, the scattering power variation and their impacts on upstream signals with different transmission fiber lengths and incident powers in a single-fiber bidirectional passive optical network (PON) communication system. The results show that both spontaneous scattering and simulated scattering can take place. The power and spectrum of backscattering noises are determined by the downstream launch power, laser linewidth and transmission fiber length. With the transmission length increasing, the power of backscattering noises gets higher, the spectrum of the backscattering noise broadens and the simulated threshold power decreases. The backscattering noise can beat with uplink light to modulate envelop of upstream signal resulting in degradation of BER greatly. Under the condition of one single channel for the second next generation PON (NG-PON2), the fiber length is 40km and downstream launch power is up to 11dBm. At this time, the backscattering noises are easy to be stimulated and the scattering power rises up from −20dBm to 10dBm, which can overwhelm the US signal. The spectrum of the optical beat interference noise also rises up with fiber length, which causes the uplink’s BER degradation. The experimental results are significant for mitigation of backscattering noises under the condition of bidirectional PONs.
This paper fundamentally investigates the peak-to-average power ratio (PAPR) theory in all optical orthogonal frequency division multiplexing (OFDM) systems which employ intensity modulation-direct detection (IM-DD) scheme. We propose a low-complexity PAPR reduction scheme based on phase pre-emphasis. Simulations show that the proposed scheme brings about a 3.74 dB PAPR reduction and better nonlinear impairment tolerance in a 16×10Gb/s IM-DD all optical OFDM system.
Frequency offset estimation algorithms for M-ary quadrature amplitude modulation based on the maximization of the periodogram of fourth-power samples have been investigated. In this letter, a low complexity estimation algorithm using interpolated discrete Fourier transform approach is introduced to replace the gradient descent (GD) or the chirp z transform (CZT) methods. The numerical simulations and complexity analysis demonstrate that the proposed estimator has much lower computational complexity than that of GD and CZT without performance degradation.
16 December 2016 in Journal of Optical Communications and Networking
We propose and experimentally demonstrate a novel ring-based wavelength-division-multiplexing passive optical network (WDM-PON). By using an orthogonal coding and correlation technique, the ring-based WDM-PON can efficiently mitigate the optical beat interference noise induced by Rayleigh backscattering. In our proposed orthogonal coding scheme, no extra light sources are required for the upstream (US) transmission, which means the number of light sources can be halved and the saved wavelengths can be used for more optical network units. In addition, compared to previous ring-based WDM-PONs, the proposed ring-based WDM-PON requires fewer fiber Bragg gratings and no blue/red-band filter, which means the proposed orthogonal coding scheme costs less. The performance of the proposed scheme is investigated through an experiment. In the experiment, 2.5 and 5 Gb/s US data rate and 5 Gb/s downstream data rate are investigated in two different ring architectures. According to the experimental results under different situations, it can be concluded that the US orthogonal coding scheme performs better than the normal US on–off keying in a ring-based WDM-PON. The power margin can be up to 1.8 dB when the US data rate is 2.5 Gb/s, and the power margin can be up to 1.69 dB when the US data rate is 5 Gb/s.
This paper proposes a novel optical time domain reflectometry (OTDR) method based on the digital linear frequency modulation (LFM) pulse, which can achieve a tradeoff between maximum measurable distance and spatial resolution. Direct modulation and detection are adopted at the transmitting and receiving ends, respectively, which is simple in construction and does not require additional optics. The short-time fractional Fourier transform (STFrFT) is introduced for the signal processing and noise filtering. The theoretical analysis of the working principle confirmed that the spatial resolution is determined by the sweep frequency range of the digital LFM signal rather than the pulse width. The influence of the STFrFT window on the peak sidelobe ratio of the reflection peak is also studied. By combining STFrFT and sidelobe suppression, the dynamic range and spatial resolution can be appreciably enhanced simultaneously. In the demo experiments testing the proposed method on a conventional OTDR development board for comparison, a 7-dB improvement in the dynamic range and an approximately 10-times improvement in the spatial resolution are simultaneously achieved.