William (Bill) Iversen

Mr. William (Bill) Iversen


Research Focus & Metrics

Academic Career Length

7Years (2020-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 February 2020 in Sensors
Verified
Journal Article
Open access
PDF file
JJJay D Jabro
Jay D Jabro
WSWilliam Bart Stevens
William Bart Stevens
WIWilliam (Bill) Iversen
William (Bill) Iversen
BAB.L. Allen
B.L. Allen
Upendra M SainjuUpendra M Sainju
Upendra M Sainju
Data-driven irrigation planning can optimize crop yield and reduce adverse impacts on surface and ground water quality. We evaluated an irrigation scheduling strategy based on soil matric potentials recorded by wireless Watermark (WM) sensors installed in sandy loam and clay loam soils and soil-water characteristic curve data. Five wireless WM nodes (IRROmesh) were installed at each location, where each node consisted of three WM sensors that were installed at 15, 30, and 60 cm depths in the crop rows. Soil moisture contents, at field capacity and permanent wilting points, were determined from soil-water characteristic curves and were approximately 23% and 11% for a sandy loam, and 35% and 17% for a clay loam, respectively. The field capacity level which occurs shortly after an irrigation event was considered the upper point of soil moisture content, and the lower point was the maximum soil water depletion level at 50% of plant available water capacity in the root zone, depending on crop type, root depth, growth stage and soil type. The lower thresholds of soil moisture content to trigger an irrigation event were 17% and 26% in the sandy loam and clay loam soils, respectively. The corresponding soil water potential readings from the WM sensors to initiate irrigation events were approximately 60 kPa and 105 kPa for sandy loam, and clay loam soils, respectively. Watermark sensors can be successfully used for irrigation scheduling by simply setting two levels of moisture content using soil-water characteristic curve data. Further, the wireless system can help farmers and irrigators monitor real-time moisture content in the soil root zone of their crops and determine irrigation scheduling remotely without time consuming, manual data logging and frequent visits to the field.

22 November 2024 in Land
Verified
Journal Article
Open access
PDF file
JJJay D Jabro
Jay D Jabro
WSWilliam Bart Stevens
William Bart Stevens
WIWilliam (Bill) Iversen
William (Bill) Iversen
Upendra M SainjuUpendra M Sainju
Upendra M Sainju
BABrett Allen
Brett Allen
CCChengci Chen
Chengci Chen
Tillage practices significantly impact soil structure, pore-size distribution (PSD), and soil-water retention curves (SWRC). The SWRC, which represents the relationship between soil water content and soil water potential, is important for various studies involving plants, soil, environment, irrigation, drainage, modeling, and hydrology. In this study, the HYPROP method was used to measure SWRCs and estimate soil physical and hydraulic properties under conventional tillage (CT), strip tillage (ST), and no-tillage (NT) systems in clay loam soil. Undisturbed soil cores were collected from 0–15 cm and 15–30 cm depths within sugarbeet rows, with sampling replicated five times following a randomized block design. Soil-water retention curves were modeled using the van Genuchten (vG) model for each depth under each tillage system. The results showed that none of the soil parameters from the vG equation, plant-available soil water content, or pore-size distribution were significantly influenced by tillage type. This lack of significant difference may be attributed to considerable soil disturbance from sugarbeet root harvesting, freeze and thaw cycles between tillage and sampling, or soil displacement caused by beet root growth. However, small differences in soil parameters among the three tillage systems were noted at both soil depths, due to minor variations in soil porosity and pore-size distribution. Regardless of the tillage system, understanding SWRC is essential for insights into soil and water processes such as water flow, soil water storage, and water availability for plants.

13 September 2023 in Soil Systems
Verified
Journal Article
Open access
PDF file
JJJay D Jabro
Jay D Jabro
WSWilliam Bart Stevens
William Bart Stevens
WIWilliam (Bill) Iversen
William (Bill) Iversen
Upendra M SainjuUpendra M Sainju
Upendra M Sainju
BABrett L. Allen
Brett L. Allen
Tillage management practices have a dynamic impact on soil hydraulic properties and processes. There is a need for information about the effect of tillage practices on soil hydraulic properties for crops growing under sprinkler irrigation in the northern Great Plains. A long-term study was conducted from 2014 to 2018 to examine the effect of no tillage (NT) and conventional tillage (CT) on the saturated hydraulic conductivity (Ks) of a sandy loam soil in a two-year corn (Zea mays L.)–soybean (Glycine max L.) rotation. In situ Ks measurements were taken in the center of crop rows within NT and CT plots using a pressure ring infiltrometer at the soil surface (0–15 cm) and a constant head well permeameter at the subsurface (15–30 cm). Results indicated that Ks values were well described by a log-normal distribution at both depths. Results showed that logarithmic Ks (log Ks) was not significantly impacted by tillage. Averaged over the five-year study, the log-transformed Ks of 100 measurements was not significantly affected by tillage in the surface layer under either corn or soybean nor in the subsurface layer under soybean. However, the mean soil log Ks in CT plots (1.784 mm h−1) was significantly greater than that in NT plots (1.186 mm h−1) in the 15–30 cm layer under corn, while Ks was nearly 50% greater in CT than in NT. Large values for the coefficient of variation (CV%) of Ks measurements exhibited significant spatial variations of Ks among plots within each tillage treatment at both the soil surface and subsurface layers under corn and soybean. Thus, more studies under different soils and cropping systems with a larger sample size per treatment are needed to lower spatial variability within treatments and validate the effect of tillage on soil hydraulic properties.

30 September 2025 in Agronomy
Verified
Journal Article
Open access
PDF file
JJJay D Jabro
Jay D Jabro
WSWilliam Bart Stevens
William Bart Stevens
WIWilliam (Bill) Iversen
William (Bill) Iversen
Upendra M SainjuUpendra M Sainju
Upendra M Sainju
BABrett L. Allen
Brett L. Allen
SDSadikshya Rana Dangi
Sadikshya Rana Dangi
Tillage practices can significantly impact soil structure and pore size distribution and connectivity, consequently affecting the shape of the soil water retention curve (SWRC) and its related estimated hydraulic parameters in the top layer of soil. This study investigated the effect of no-tillage (NT) and conventional tillage (CT) practices on SWRCs and their soil hydraulic parameters, estimated by the Brooks–Corey (BC) function at 0–15 and 15–30 cm depths within sugarbeet and corn planting rows in clay loam and sandy loam soils, respectively. Soil water retention curves were measured using the evaporative method (HYPROP). Measured SWRC results were modeled for both untilled and tilled soils using the BC function for each depth in both soils. In clay loam, results indicated that all soil parameters of the BC function, water contents at 330 (θ330) and 15,000 (θ15,000) hPa, and plant available soil water content (AW) were not significantly affected by the type of tillage at either soil depth. The lack of difference in results between NT and CT may be due to considerable soil disturbance, primarily by the harvest process of sugarbeet roots. However, in sandy loam, results indicated that differences occurred in SWRC’s estimated parameters between the NT and CT practices. Averaged across 4 years and two soil depths, the pore size distribution index (λ) and saturated water content (θs) were significantly larger under CT than under NT due to greater soil loosening and disturbance caused by multiple passes of the CT process, thereby developing more soil macroporosity. However, the θ330 and AW were significantly larger in NT than in CT due to reduced soil disturbance and improved soil structure under NT compared to CT practices. Regardless of tillage, measurements of SWRC are important for determining better irrigation management practices, enabling producers to optimize crop productivity, while saving water and sustaining water quality.

7 July 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
WIWilliam (Bill) Iversen
William (Bill) Iversen
WSWilliam Bart Stevens
William Bart Stevens
JJJay D Jabro
Jay D Jabro
Hand-held soil penetrometers can impose physical strain and ergonomic discomfort on operators, particularly during repeated use or in challenging soil conditions. To address these limitations, three mechanically assisted penetrometer embodiments were developed that use the operator’s static body weight as an anchoring force. Bipod and tripod designs incorporated an electric linear actuator to assist with inserting and retracting a commercially available penetrometer rod. A third embodiment—a monopod—was constructed using readily available structural and electronic components in a novel configuration that integrates a linear actuator for mechanical assistance, a potentiometer for depth measurement, and a base plate on which the operator stands to stabilize the device. The combination of the potentiometer, base plate, and vertical support structure enabled reliable operation in high-residue fields, beneath crop canopies, and in windy conditions where conventional hand-held units often fail. All three embodiments reduced physical and ergonomic strain while improving data quality. Among them, the monopod demonstrated the highest depth-measurement accuracy, eliminated insertion-rate errors, and provided the greatest reduction in operator strain, making it the preferred design.