Ricardo Jorgensen Cassella

Dr. Ricardo Jorgensen Cassella


Research Focus & Metrics

Academic Career Length

29Years (1998-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
15 July 2005 in Talanta
Verified
Journal Article
Closed access
RCRicardo Jorgensen Cassella
Ricardo Jorgensen Cassella
OMO Magalhaes
O Magalhaes
MCM Couto
M Couto
ELE Lima
E Lima
MNM Neves
M Neves
FCF Coutinho
F Coutinho

1 November 2008 in Journal of Hazardous Materials
Verified
Journal Article
Closed access
EBEliene E. Baldez
Eliene E. Baldez
NRNicolle F. Robaina
Nicolle F. Robaina
RCRicardo Jorgensen Cassella
Ricardo Jorgensen Cassella

15 February 2006 in Talanta
Verified
Journal Article
Closed access
RSRicardo Erthal Santelli
Ricardo Erthal Santelli
MBM Bezerra
M Bezerra
ODO Desantana
O Desantana
RCRicardo Jorgensen Cassella
Ricardo Jorgensen Cassella
SFS Ferreira
S Ferreira

1 July 2011 in Chemical Engineering Journal
Verified
Journal Article
Closed access
LRLuís Gustavo T. dos Reis
Luís Gustavo T. dos Reis
NRNicolle F. Robaina
Nicolle F. Robaina
WPWagner F. Pacheco
Wagner F. Pacheco
RCRicardo Jorgensen Cassella
Ricardo Jorgensen Cassella

3 September 2010 in Journal of Analytical Atomic Spectrometry
Verified
Journal Article
Closed access
PDF file
RCRicardo Jorgensen Cassella
Ricardo Jorgensen Cassella
DBDaniel M. Brum
Daniel M. Brum
CPCarlos Eduardo R. de Paula
Carlos Eduardo R. de Paula
CLClaudio F. Lima
Claudio F. Lima
This present work reports a novel strategy for the extraction of metals (Cu, Fe, Ni and Pb) from diesel oil and their determination by Electrothermal Atomic Absorption Spectrometry (ETAAS). The method is based on the formation of water-in-oil emulsions by vigorous mixing of the samples with a Triton X-114 solution containing HNO3 and posterior breaking of the emulsion by heating. After the emulsion breaking, three well separated phases were obtained: (i) the upper phase, which is an organic phase containing only the diesel oil, (ii) an acidic aqueous phase containing the extracted metals and (iii) the lower phase, which is a surfactant-rich phase. The metals were concentrated in the aqueous phase, as a result of their acidic extraction from diesel oil. Several parameters that could influence the extraction efficiency and the time required to break the emulsions were evaluated such as the concentration and nature of the surfactant (Triton X-100 and Triton X-114), the HNO3 concentration and the temperature. At best conditions, the emulsions were prepared by mixing 10 mL of diesel oil with 2 mL of a solution containing 7% w/v Triton X-114 and 10% v/v HNO3. Afterwards, the emulsions were broken by heating at 80 °C for 15 min and then, the aqueous phase was collected and the metals were determined by ETAAS using external calibration with aqueous standard solutions. The limits of detection for Cu, Fe, Ni and Pb were equal to 114, 183, 145 and 294 ng L−1 and the limits of quantification were 380, 609, 484 and 980 ng L−1, respectively. These limits were estimated for the original sample taking into account the preconcentration factor obtained due to the Extraction Induced by Emulsion Breaking (EIEB) application. The novel strategy was applied in the analysis of five samples of diesel oil and the obtained results fitted well with those obtained by the reference method. Also, a recovery test was performed by spiking the samples with known amounts of the metals in the form of organometallic standards and thus applying the proposed procedure. The recoveries were in the range of 85.2–109%.