In recent years, significant progress in thermoelectric module (TEM) technology has been achieved in terms of both flexibility and efficiency. This has created great application potential for it, including in cooling garments. In this paper, the results from performance tests of six selected flexible TEMs are presented and discussed in terms of their applicability in a cooling garment. For this purpose, a special testing methodology was adopted that included the use of a skin model located in a microclimate chamber that allowed the analysis of the absorbed heat flow rate from the cold side of a TEM. In addition, electrical parameters were measured in order to calculate the coefficient of performance for each of the evaluated TEMs. Based on these measurements, the TEMs were compared in terms of the cold-side heat flow rate and the number of modules needed to achieve a given heat flow rate or total cooling surface area. The best results were achieved for the TEM with dimensions of 85 mm × 68 mm × 6 mm, for which a maximum heat flow rate of 1.39 W was achieved with an electrical supply power of 0.35 W. To achieve similar values with other evaluated TEMs, two to five modules would have to be applied.

Bacterial biofilm on implants may cause inflammation, which disturbs the process of the implant’s integration with the surrounding tissues. Such problems are becoming critical for patients’ health, especially in connection with the presence of antibiotic-resistant bacterial strains. Among the existing alternatives for drug treatments are natural-based substances. This study focused on the examination of silica coatings with curcumin and thymol, which were deposited using the sol-gel method on 3D printouts made of Ti6Al4V ELI. This substrate material is commonly used in medicine. The selective laser melting technique used for the manufacturing of samples was in line with the existing procedures applied for individual orthopedic implants. The examination involved the assessment of the coatings’ morphology, chemical composition, and biological effect. The antibacterial properties were tested using a flow cytometer using Escherichia coli, and the cytotoxicity on Saos-2 cells was assessed using the LIVE/DEAD test. The obtained results showed that it is possible to produce silica sol-gel coatings with the addition of specific natural substances in concentrations assuring a bacteriostatic effect. The produced coatings did not show any cytotoxic effect, which confirms the possibility of using both curcumin and thymol as additives to coatings used in medicine, e.g., for orthopedic implants.