Cube and tensile samples of reduced activation ferritic/martensitic steel were formed at different laser powers and scanning velocities using a selective laser melting process; the microstructural characteristics and tensile properties of the cube and tensile samples were investigated in this study. The experimental results showed that the SLMed CLF-1 samples that formed with selected laser melting were near-fully dense, and the relative density of the SLMed CLF-1 samples exceeded 99%. Meanwhile, there were numerous nano-sized spherical and needle-like precipitate dispersions distributed in the grains and boundary of the grains, and the precipitates were mainly composed of M23C6 carbide and MX carbide. The microstructure was composed of columnar grains and equiaxed grains arranged in a sequence, and the smallest average size of the grains was 15 ± 2.1 µm when measured at 320 W of power and 800 mm/s scanning velocity. In addition, the sample at 320 W of power and 800 mm/s scanning velocity exhibited higher yield strength (875 ± 6.0 MPa) and higher elongation (25.6 ± 0.8%) than that of the sample at 200 W of power, 800 mm/s scanning velocity, yield strength of 715 ± 1.5 MPa, and elongation of 22.6 ± 1.2%.

Nano-sized tungsten exhibits superior properties due to its high-density grain boundaries’ strengthening. The high-quality nano-sized powder is essential for sintering nano-sized tungsten bulks through powder metallurgy techniques. In this study, nano-sized tungsten powder was successfully synthesized by mechanochemical methods using mixed WO₃ and Mg powders. The effects of processing parameters on the morphology and microstructure of synthesized powder were thoroughly investigated. The results reveal that the thermite reaction of WO₃ and Mg is almost complete after 5 min of ball milling at a speed of 300 rpm. The average grain size of the tungsten powder decreases with the increasing milling duration and speed. Optimal average grain size and purity were achieved at a milling speed of 300 rpm and a milling duration ranging from 30 to 120 min. Moreover, centrifugation sieving further reduces the average grain size of tungsten powder to 19.5 nm. In addition, the entire mechanochemical process can be divided into two stages: the reaction stage and the grain size refinement stage.

The stability of nanoparticles (NPs) in ODS steel is an important factor affecting their long-term service behavior. In the current work, the 9Cr-ODS steel samples were irradiated using 3.5 MeV Fe¹³⁺ ion irradiation up to 20 dpa at 350–650 °C, and the microstructure stability was studied using the transmission electron microscope. The correlation between the particle coarsening rate and the irradiation depth has been investigated. The results show that fine Y-Ti-O NPs undergo coarsening under irradiation at 350 and 500 °C, and the coarsening rate shows a trend of first increasing and then decreasing with the increase in depth. NP coarsening reached its peak at a certain depth, and the peak depth increased with the increase in irradiation temperature. While the coarsening was inhibited at 650 °C, almost no changes in particle size were observed, only slightly coarsening at the end of the irradiation layer. In addition, b = 1/2 type dislocation loops were dominant at 350 °C, and the formation of b = type dislocation loops was confirmed at 500 °C. Dislocation lines were formed at 650 °C. Additionally, the segregation of Cr, O, C, Y, and Ti toward the surface in the irradiated layer was observed due to the surface effect. The stability of NPs with irradiation temperature is discussed.