Pyrophyllite is widely used both as a gasket material and as a pressure-transmitting medium, especially for a large-volume press. Its pressure-transmitting efficiency mainly depends on the following factors: geometry of anvil and pyrophyllite block, chemical composition, density and strength. For a long time, most studies have been devoted to the first two factors, whereas the third one has been studied less. In this work, we report that the pressure-transmitting efficiency of pyrophyllite is improved by precompressing. The results show that pyrophyllite was fully densified when the pressure reached about 1 GPa. The press load for Ba I–II transition in the cubic large-volume pressure cell is reduced more than 8×105 N by using the densified pyrophyllite, compared with the unprecompressed pyrophyllite. Namely, the press-load utilization efficiency was improved above 15% when the precompressed pyrophyllite is used as a pressure-transmitting medium.
Luminescent materials that simultaneously embody bright singlet and triplet excitons hold great potential in optoelectronics, signage, and information encryption. However, achieving high-performance white-light emission is severely hampered by their inherent unbalanced contribution of fluorescence and phosphorescence. Herein, we address this challenge by pressure treatment engineering via the hydrogen bonding cooperativity effect to realize the mixture of n–π*/π–π* transitions, where the triplet state emission was boosted from 7% to 40% in isophthalic acid (IPA). A superior white-light emission based on hybrid fluorescence and phosphorescence was harvested in pressure-treated IPA, and the photoluminescence quantum yield was increased to 75% from the initial 19% (blue-light emission). In-situ high-pressure IR spectra, X-ray diffraction, and neutron diffraction reveal continuous strengthening of the hydrogen bonds with the increase of pressure. Furthermore, this enhanced hydrogen bond is retained down to the ambient conditions after pressure treatment, awarding the targeted IPA efficient intersystem crossing for balanced singlet/triplet excitons population and resulting in efficient white-light emission. This work not only proposes a route for brightening triplet states in organic small molecules, but also regulates the ratio of singlet and triplet excitons to construct high-performance white-light emission.
The polyacrylamide gel method has been developed for fabrication of Ba1−xSrxTiO3(BST) photocatalysts. The structure, surface morphology, band gap and photocatalytic activity of BST photocatalysts can be regulated by adjusting thexvalue.
24 March 2021 in Journal of Materials Science: Materials in Electronics
We developed a novel technique to synthesize nanodiamond powder through the decomposition of graphitic C3N4 under high pressure and high temperature. The nanodiamond obtained by the present method is in an extremely pure form with no sp2 carbon contaminations. Individual nanodiamond grains are very uniform in size and virtually monodispersed single crystals. The grain size can be controlled from less than 1 nm to several hundred nanometers by adjusting the heating temperature (and also potentially by controlling pressure) used for the synthesis. The present product requires neither post‐surface treatment to remove outer shell made of sp2 carbons nor deglomeration and size classification unlike the case for nanodiamond obtained by the conventional TNT detonation method.