Reinforced magnesium metal matrix nanocomposites (MMMNCs) have piqued the interest of scientific community in recent years. Friction stir processing (FSP) is a known process to achieve the highest level of secondary phase nanocomposites distribution in the base monolithic matrix. In this study, an attempt has been made to synthesize magnesium base AZ61A/n-TiC nanocomposites using FSP and the influence of tool rotational speed on the metallurgical, mechanical, and tribological behavior of the developed composites has been studied. Microstructural examination shows that as tool rotational speed increases, high plastic deformation occurs and heat is generated along with the concomitant shattering impact of rotation, which consequently develops larger grains in the stir zone. However, this also provides thrusts resulting in uniform distribution of the nanoparticles in the base matrix. Microhardness and ultimate tensile strength of the developed nanocomposite were found to be significantly improved when contrasted with the base metal. Lower wear rate was observed for the composite developed at 800 rpm along with the abrasive type of wear mechanism.
Metal matrix composites (MMCs) are the next generation materials, globally popular for having numerous potential applications in aircraft, automobile and biomedical industry. Magnesium being continuously replacing other conventional materials however it is a hard to process material. Recently, friction stir processing (FSP) is drawing attention among researchers to fabricate MMCs. Using FSP, superior properties of magnesium based MMCs being successfully achieved. The primary aim of this paper is to review and provide a thorough summary of FSP synthesized magnesium based composites. Additionally the effect of secondary phase particles on the tribological behavior of produced composite materials is also summed up. Mechanical along with microstructural properties produced from stirred process and contribution of strengthening mechanism is addressed, as well.
6 June 2024 in Journal of Materials Engineering and Performance
Utilizing waste materials like fly ash in the creation of lightweight magnesium metal matrix composites with a high strength-to-weight ratio is encouraged by the rising demand for in-expensive reinforcements. In the current study, friction stir processing (FSP) was employed to synthesize magnesium surface composites via incorporating hybrid reinforcement particles, including nano titanium carbide and fly ash. The synthesized composite material underwent examination through microscopic images of the stir zone and assessments of microhardness, tensile strength, compressive strength, electrical and thermal conductance, and wear behavior. The results revealed a notable refinement in grain size and a simultaneous improvement in mechanical properties. Notably, there was a substantial increase in wear resistance attributed to the increased hardness and uniform dispersion of hybrid reinforcements within the surface composite. The results demonstrate that the inclusion of reinforcements in magnesium-based alloy led to an enhancement in fracture toughness, mitigation of crack propagation, and an overall improvement in fracture resistance to catastrophic failure.
1 June 2024 in Materialwissenschaft und Werkstofftechnik