Introduction of biomass-based nanofillers into the polyamide matrix may represent a sustainable approach for the development of high-performance engineering plastics. From this standpoint, nanocellulose, derived from various cellulosic sources, has attracted a great deal of attention because of is exceptional mechanical properties, lightweight nature, and biodegradability, which presents significant advantages over conventional inorganic fillers. However, a technical challenge arises in the industrially favorable melt processing of polyamides and nanocellulose. This challenge is associated with the thermal degradation of nanocellulose at high processing temperatures, as well as the strong tendency of nanocellulose to aggregate within the polymer matrix. This review examines recent developments to address these issues. Key approaches based on the surface treatment of nanocellulose as well as optimization of processing conditions are discussed in detail, which can provide insights on the development of nanocellulose-reinforced polyamide composites.
Recently, the development of biomass-based polymers has attracted a great deal of attention as a sustainable alternative to petroleum-based plastics. However, the relatively limited mechanical properties of these bio-derived polymers often require reinforcement through the inclusion of nanofillers, while the environmental durability of such nanocomposites remains insufficiently understood. In this regard, we prepared nanocomposites composed of isosorbide-based polycarbonate (ISB-PC) and surface-modified cellulose nanocrystals (CNCs), and examined the effect of nanofillers on the mechanical properties and their retention under humid soil exposure. Interestingly, the initial reinforcement effect provided by CNCs rapidly decreased during the early stage of exposure, and the mechanical properties of the ISB-PC composites eventually converged toward those of pristine ISB-PC within a relatively short time. Based on the time-dependent changes in mechanical properties and mass loss, we propose that the mechanical deterioration was associated with physical changes in the polymer matrix, accompanied by the formation of macroscale cavities within the films. Our results suggest that initial reinforcement does not necessarily ensure sustained mechanical performance under humid soil exposure.